408-9514 Datasheet, PDF (1/2 Pages) Tyco Electronics – Reasons for reissue of this instruction sheet are provided in Section 5, REVISION SUMMARY

Extraction Tool 844751-1
Instruction Sheet
408-9514
18 SEP 07 Rev A
Handle
Tool Stop
Tip
2. DESCRIPTION
The extraction tool consists of a plastic handle, a
steel blade tip with a chamfered edge, and a tool
stop.
When inserted into the terminal cavity of the
connector, the tip of the tool functions as a release,
depressing the locking lance slot of the terminal to
allow extraction of the terminal from the connector.
The tool stop prevents over insertion of the tip in the
cavity and prevents the connector housing from being
damaged during the extraction of the terminal.
Figure 1
1. INTRODUCTION
Extraction Tool 844751–1 shown in Figure 1 is
designed to remove Generation II Timer Control
Terminals (reference part number 770642–1) from
Standard Timer Connectors.
NOTE
i
Dimensions in this instruction sheet are in
millimeters [with inches in brackets]. Figures are
not drawn to scale.
Reasons for reissue of this instruction sheet are
provided in Section 5, REVISION SUMMARY.
3. USING THE TOOL
1. Align the tool tip with the cavity of the terminal to
be removed. The tool tip must be positioned so
that the chamfered edge of the tip is facing the
locking feature slot of the cavity (this slot is on one
side of the cavity only). Refer to Figure 2.
2. Gently insert the tool tip into the cavity until the
tool stop butts against the connector. See Figure 3,
Detail A.
3. Gently push the tool, and tilt the tip away from
the locking feature slot to release the locking lance
(inside the connector) from the locking lance slot of
the terminal. See Figure 3, Detail B.
4. Simultaneously pull back on the wire to remove
the terminal from the wire end of the connector.
Connector (Ref)
Locking Feature Slot
of Terminal Cavity
Generation II Timer Control
Terminal (Shown Removed
for Clarity)
Locking
Lance Slot
Chamfered
Edge of Tip
Locking Feature Slot
of Terminal Cavity
Figure 2
E2007 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 2
LOC B