408-9452 Datasheet, PDF (2/2 Pages) Tyco Electronics – This instruction sheet covers Extraction Tools

Extraction Tools 843475-1 and -2
A
B
408-9452
TOOL
PN
843475-1
843475-2
DIMENSIONS
A
5.59 [.220]
16.51 [.650]
B
0.84 [.033]
1.52 [.060]
12.70 [.500]
0.51 [.020]
17.78 [.700]
144.78 [5.700]
3.81 [.150]
6.35 [.250]
Figure 3
3.1. Front Release Housing (843475-1)
Refer to Figure 1 and proceed as follows:
1. Align extraction tip with locking lance release
slot at FRONT of desired contact cavity.
lance and, simultaneously, pull back on wire. The
contact will come out easily.
5. Repeat these procedures until designated
contact is removed.
2. Insert tip straight into slot until it bottoms.
3. Hold tool in position and pull back on wire; the
contact will come out easily.
4. Remove extraction tool from FRONT of housing.
3.2. Side Release Housing (843475-2)
Refer to Figure 2 and proceed as follows:
1. Note that a solid rib extends through the center
of the housing. Determine from which half of the
housing the contact is accessible.
2. Align extraction tip with appropriate locking
lance release slot in side of housing.
3. Insert tip straight into slot until it touches a
contact. Note that this could be the first contact in
the row – not necessarily the contact to be
removed. Make certain tool is perpendicular to the
housing.
4. Grip wire of first contact in slot. Apply slight
inward pressure on tool to depress contact locking
4. TOOL INSPECTION/MAINTENANCE
Extraction Tool 843475–[ ] should conform to the
dimensions listed in Figure 3. It is recommended that
each tool be inspected upon arrival to be sure it has
not been damaged in transit, and at regularly
scheduled intervals to be sure it remains functional.
Order replacements through your Tyco Electronics
Representative, or call 1–800–526–5142, or send a
facsimile of your purchase order to 717–986–7605, or
if the tool requires repair, send it with a written
description of the problem to:
CUSTOMER SERVICE (038–035)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105–3608
5. REVISION SUMMARY
S Updated document to corporate requirements
S New format
2 of 2
Tyco Electronics Corporation
Rev A