408-9240 Datasheet, PDF (2/3 Pages) Tyco Electronics – Cumulative Trauma Disorders can result from the prolonged use ofmanually powered hand tools.

Clinching Tool 91117- 6
408- 9240
Tool Lower
Jaw
Rear of Pin Header
530744 (Ref)
Rivet 534164- 2
(Ref)
Key Cavity
External Key
530721 (Ref)
Punch Tip
Tool Upper
Jaw
Figure 3
3. Open tool handles and position tool
perpendicular to pin header.
4. Place lower jaw against rivet and rear of header,
and close tool punch tip through key mounting
hole.
5. Squeeze tool handles together until key presses
into cavity and jaws are bottomed.
6. Remove tool and, if required, repeat these
procedures on the other end of header. Be sure
that the key is properly oriented.
4. MAINTENANCE AND INSPECTION
The clinching tool should be inspected immediately
upon arrival at your facility to ensure that the tool has
not been damaged during handling. The tool should
also be inspected at regularly scheduled intervals to
ensure proper operation of the tool.
4.1. Daily Maintenance
It is recommended that each operator of the tool be
made aware of—and responsible for—the following
steps of daily maintenance.
1. Remove dust, moisture, and other contaminants
with a clean brush, or a soft lint--free cloth.
2. Make sure that the proper retaining pins are in
place and secured with the proper retaining rings.
3. Be sure all pins, pivot points, and bearing
surfaces are protected with a THIN coat of SAE 20
motor oil. DO NOT oil excessively.
5. REPLACEMENT AND REPAIR
Customer--replaceable parts are listed in Figure 4.
A complete inventory should be stocked and
controlled to prevent lost time when replacement of
parts is necessary. Parts other than those listed
should be replaced by Tyco Electronics to ensure
quality and reliability. Order replacement parts
through your representative, or call 1--800--526--5142,
or send a facsimile of your purchase order to
717--986--7605, or write to:
CUSTOMER SERVICE (038--035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105--3608
For customer repair service, call 1--800--526--5136.
6. REVISION SUMMARY
Revisions to this instruction sheet include:
S Updated document to corporate requirements
SAE is a trademark of SAE International Corporation.
2 of 3
Tyco Electronics Corporation
Rev C