408-9240 Datasheet, PDF (1/3 Pages) Tyco Electronics – Cumulative Trauma Disorders can result from the prolonged use ofmanually powered hand tools.

Clinching Tool 91117- 6
For Mini- Box Pin Headers
Instruction Sheet
408- 9240
23 MAR 10 Rev C
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended- use, production operations is available.
Handles
Setscrew
Tool Upper Jaw
Punch
Tool Lower Jaw
Figure 1
1. INTRODUCTION
Clinching Tool 91117--6 is designed to install external
keys into Mini--Box pin headers to provide polarization
of mating connectors. Read these instructions
thoroughly before using the tool.
NOTE
i
Dimensions in this instruction sheet are in metric
units [with U.S. customary units in brackets].
Figures are not drawn to scale.
handles and measure the distance between the
punch tip and the lower jaw. If necessary, adjust the
setscrew to obtain a clearance of 0.508 mm
[.020 in.]. See Figure 2.
0.508 mm [.020 in.]
Clearance
(With Jaws Bottomed)
Reasons for reissue of this instruction sheet are
provided in Section 6, REVISION SUMMARY.
2. DESCRIPTION (Figure 1)
The clinching tool features an upper jaw and a lower
jaw. The upper jaw contains a replaceable punch
which clinches the key in the pin header. The lower
jaw supports the rivet and header when the tool
handles are closed.
3. CLINCHING PROCEDURE
Before starting, be sure that the pin header and
external key are compatible. Also, close the tool
Figure 2
Refer to Figure 3, and proceed as follows:
1. Determine the keying position required.
2. Place key into cavity at desired position.
CAUTION
!
The clinching tool can be used for simultaneous
installation of key and rivet into brown pin
headers. However, for black or gray pin headers,
the key must be inserted using Clinching Tool
91117- 2 (see 408- 7894), before securing key
with rivet using this clinching tool.
E2010 Tyco Electronics Corporation, Berwyn, PA
TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products names, logos, or company names might be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 3
LOC B