408-8648 Datasheet, PDF (2/2 Pages) Tyco Electronics – Screws on Tooling Tip facing upwards

Insertion Tool 1583255-1
Insertion Tool
HM-Zd Connector
Printed Circuit
Board
Figure 3
Screw Heads
on Opposite
Side of Tool
Tooling
Tip
2 of 2
Figure 4
408-8648
4. TOOL INSPECTION
It is recommended that the tool be inspected
immediately upon its arrival in your plant to ensure
that it has not been damaged during shipment.
5. MAINTENANCE/INSPECTION
5.1. Daily Maintenance
It is recommended that each operator be made aware
of, and responsible for, the following steps of daily
maintenance:
1. Remove dust, moisture, and other contaminants
with a clean, soft brush, or lint–free cloth. Do NOT
use objects that could damage the tool or any of its
components.
2. When the tool is not in use, store it in a clean,
dry area.
5.2. Periodic Inspection
Regular inspections should be performed by quality
control personnel. A record of scheduled inspections
should remain with the tool or be supplied to
supervisory personnel responsible for the tool. The
inspection frequency should be based on the amount
of use, working conditions, operator training and skill,
and established company standards.
6. REPLACEMENT AND REPAIR
Post _{Order replacement seating tools through your Tyco}
Electronics representative, or call 1–800–526–5142,
or send a facsimile of your purchase order to
1–717–986–7605 or write to:
CUSTOMER SERVICE (38–35)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105–3608
For seating tool repair service, please contact a Tyco
Electronics representative at 1–800–526–5136.
7. REVISION SUMMARY
Revisions to this instruction sheet include:
S Updated document to corporate requirements.
Tyco Electronics Corporation
Rev A