408-8647 Datasheet, PDF (2/2 Pages) Tyco Electronics – Press down evenly on the tool until the rear leg bottoms on the pc board.

HM-Zd Chicklet Removal Tools 1583248-1 and 1583249-1
408-8647
6. Discard the chicklet.
2.29 [.09]
A
4. MAINTENANCE AND INSPECTION
4.1. Daily Maintenance
It is recommended that each operator be made aware
of, and responsible for, the following steps of daily
maintenance:
1. Remove dust, moisture, and other contaminants
with a clean, soft brush, or lint–free cloth. DO NOT
use objects that could damage the tool.
2. When the tool is not in use, store it in a clean,
dry area.
4.2. Periodic Inspection
It is recommended that the tool be inspected using
Figure 3 immediately upon its arrival to ensure that it
has not been damaged during shipment.
Regular inspections should be performed by quality
control personnel. A record of scheduled inspections
should remain with the tool or be supplied to
personnel responsible for the tool. The inspection
frequency should be based on the amount of use,
working conditions, operator training and skill, and
established company standards.
5. REPLACEMENT AND REPAIR
Order removal tools through your representative, or
call 1–800–526–5142, or send a facsimile of your
purchase order to 717–986–7605, or write to:
CUSTOMER SERVICE (038–035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105–3608
For customer repair service, call 1–800–526–5136.
50.8
[2.00]
2.54
[.100]
1.27+0.00/-0 .025
[.050+.000/-.001]
4.7
[.185]
D
TOOL
1583248-1
1583249-1
DIMENSION
C
A
B
+0.025
[.001]
29.7
[1.17]
10.2
[.400]
14.2
[.560]
20.3
6.35
5.38
[.80]
[.250] [.212]
Figure 3
B
4.06
[.160]
C
D
+0.025
[.001]
21.7
[.856]
12.8
[.502]
6. REVISION SUMMARY
Revisions to this instruction sheet include:
S Updated document to corporate requirements
2 of 2
Tyco Electronics Corporation
Rev B