408-8647 Datasheet, PDF (1/2 Pages) Tyco Electronics – Press down evenly on the tool until the rear leg bottoms on the pc board.

HM-Zd Chicklet Removal Tools
1583248-1 (4-Pair Receptacle) and
1583249-1 (2-Pair Receptacle)
Instruction Sheet
408-8647
09 FEB 09 Rev B
Front Leg
Rear Leg
Middle Leg
Figure 1
1. INTRODUCTION
HM–Zd Chicklet Removal Tools 1583248–1 (4–pair
receptacle) and 1583249–1 (2–pair receptacle)
(shown in Figure 1) are designed to be used in
conjunction with HM–Zd Receptacle Removal Tools
1583224–[ ] to remove HM–Zd receptacles from the
printed circuit (pc) board.
After using the receptacle removal tool to remove the
housing from the pc board, the chicklet removal tool is
used to remove individual chicklets from the pc board.
Read and understand these instructions before using
any of the removal tools.
NOTE
i
Dimensions in this instruction sheet are in
millimeters [with inches in brackets]. Figures are
not drawn to scale.
Reasons for reissue of this instruction sheet are
provided in Section 6, REVISION SUMMARY.
the contact beam and the plastic part of the
chicklet, and the middle leg is aligned with the latch
of the chicklet. See Figure 2.
3. Press down evenly on the tool until the rear leg
bottoms on the pc board.
4. Gently rock the tool toward the front of the
chicklet, creating interference (the chicklet will pivot
out slightly).
NOTE
i
DO NOT try to pull the chicklet straight off of the
pc board; otherwise, the tool will slip off of the
chicklet.
5. Continue to rock the tool back–and–forth until
the chicklet has lifted from the housing.
See Detail A
Housing
Removed
Rear Leg
Back of
Chicklet
Detail A
PC Board
Middle Leg
2. DESCRIPTION
The removal tool features legs which protrude into
and around an individual chicklet of the receptacle
enabling the chicklet to be removed from the pc
board.
3. REMOVAL
1. Refer to instruction sheet 408–8644, and
remove the housing from the pc board.
2. Position the tool over the chicklet to be removed
so that the rear leg is aligned with the back of the
chicklet, the front leg is aligned to enter between
Front Leg
Contact
Beam
Chicklet
Latch
Figure 2
Plastic Part
of Chicklet
E2009 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 2
LOC B