408-8646 Datasheet, PDF (2/2 Pages) Tyco Electronics – Read these instructions before using the extraction tool.

Extraction Tool 1583237-1
408-8646
3.2. Pin Contact Extended Beyond Board Surface
1. Turn the adjustment cap counterclockwise until
the push pin is retracted (recessed) into the end of
the spring–loaded tip. Refer to Figure 4.
NOTE
i
Be careful not to completely unscrew the
adjustment cap. If the adjustment cap is turned
too far, the spring-loaded tip will release.
Spring-Loaded
Tip
Handle
Figure 4
Push Pin Retracted
(Recessed)
2. With the push pin retracted (recessed), locate
the tip of the pin contact (from the back side of the
pc board) to be extracted.
3. Place the spring–loaded tip over the tip of the
pin contact. See Figure 5.
4. Holding the tool perpendicular to the pc board,
apply pressure to the tool until the pin contact
(post) is ejected from the pc board and connector.
NOTE
i
It may be necessary to raise the pc board off the
work surface to allow for sufficient clearance of
the extracted pin contact.
4. MAINTENANCE AND INSPECTION
It is recommended that the tool be inspected
immediately upon its arrival to ensure that it has not
been damaged during shipment.
4.1. Daily Maintenance
It is recommended that each operator be made aware
of, and responsible for, the following steps of daily
maintenance:
1. Remove dust, moisture, and other contaminants
with a clean, soft brush, or lint–free cloth. DO NOT
use objects that could damage the tool or any of its
components.
2. When the tool is not in use, store it in a clean,
dry area.
4.2. Periodic Inspection
Regular inspections should be performed by quality
control personnel. A record of scheduled inspections
should remain with the tool or be supplied to
supervisory personnel responsible for the tool. The
inspection frequency should be based on the amount
of use, working conditions, operator training and skill,
and established company standards.
5. REPLACEMENT AND REPAIR
Order extraction tools through your representative, or
call 1–800–526–5142, or send a facsimile of your
purchase order to 717–986–7605, or write to:
CUSTOMER SERVICE (038–035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105–3608
For customer repair service, call 1–800–526–5136.
Retracted Push
Pin Over Tip of
Pin Contact
Back Side of
PC Board
6. REVISION SUMMARY
Revisions to this instruction sheet include:
S Updated document to corporate requirements
S Changed “and contact” to “and connector” in
Step 3 of Paragraph 3.1 and Step 4 of
Paragraph 3.2
Connector
2 of 2
Figure 5
Tyco Electronics Corporation
Rev A