408-8646 Datasheet, PDF (1/2 Pages) Tyco Electronics – Read these instructions before using the extraction tool.

Extraction Tool 1583237-1
Instruction Sheet
408-8646
09 FEB 09 Rev A
Adjustment
Cap
Handle
3. EXTRACTION PROCEDURE
3.1. Pin Contact Not Extended Beyond Board Surface
1. Turn the adjustment cap clockwise until the
push pin is extended (approximately 0.51 [.020])
beyond the end of the spring–loaded tip. Refer to
Figure 2.
Push
Pin
Spring-Loaded
Tip
Spring-Loaded
Tip
Figure 1
1. INTRODUCTION
Extraction Tool 1583237–1 (shown in Figure 1) is
designed to extract individual pin (post) contacts from
HM–Zd header connectors. The connectors can be
removed from the printed circuit (pc) board using
HM–Zd Header Removal Tools 1583220–1 and
1583234–1 (refer to 408–8645).
NOTE
i
Dimensions in this instruction sheet are in
millimeters [with inches in brackets]. Figures are
not drawn to scale.
Handle
Push Pin Extended
0.51 [.020] Approx
Figure 2
2. With the push pin extended, locate the
appropriate pc board hole (in the back side of the
pc board) of the pin contact to be extracted, and
place the push pin into the hole. Refer to Figure 3.
Extended Push Pin
Aligned with
Pin Contact Hole
Back Side of
PC Board
Read these instructions before using the extraction
tool.
Reasons for reissue of this instruction sheet are
provided in Section 6, REVISION SUMMARY.
Connector
2. DESCRIPTION
The extraction tool consists of a handle, adjustment
cap, spring–loaded tip, and push pin. See Figure 1.
The adjustment cap, located on one end of the
handle, can be set to allow the push pin to recess or
extend out of the spring–loaded tip while extracting
the pin contact.
The push pin pushes on the pin contact and ejects it
from the pc board and connector.
Figure 3
3. Holding the tool perpendicular to the pc board,
apply pressure to the tool until the pin contact is
ejected from the pc board and connector.
NOTE
i
It may be necessary to raise the pc board off the
work surface to allow for sufficient clearance of
the extracted pin contact.
E2009 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 2
LOC B