408-8503 Datasheet, PDF (2/3 Pages) Tyco Electronics – Seating Tool Assemblies

Seating Tool Assemblies 1424686- [ ]
408- 8503
If Applying Connector with Organizer
Insert Plate
(Removed)
Set Screw
(2 Places,
Securing
Insert Plate)
10. Move the slide plate forward (toward the front
of the press).
11. Carefully lift the pc board straight off of the
fixture board.
CAUTION
!
To avoid bending the contact posts, make sure to
carefully lift the pc board straight off of the fixture
board.
Guide Post
(2 Places)
Fixture
Board
Raised
Surface
Figure 2
5. Place the connectors on the pc board as shown
in Figure 3.
6. Grasp the handle of the slide plate, and move
the slide plate back until it stops against the two
set screw stops located at the back of the base.
Refer to Figure 3.
7. Activate the press according to instructions
included with the press to apply the first connector
onto the pc board.
8. Slide the slide plate forward to the detented
terminating position.
9. Activate the press, and seat the next connector
onto the pc board.
12. Inspect the applied connectors according to
Application Specification 114--13021. If the
application is correct, continue applying
connectors. If necessary, adjust the shut height
according to the instructions included with the
press.
4. ADJUSTMENTS
The assembly is pre--set and adjustments should not
normally be required; however, if adjustments are
necessary, proceed with the following.
4.1. Alignment (See Figure 4)
CAUTION
!
For powered presses, make sure to
DISCONNECT the power before making
adjustments.
1. Loosen the screws securing the slide plate to
the base.
2. Align the screws (in the X and Y axis) with the
center of the ram.
3. Tighten the screws that were loosened in
Step 1.
PC Board
Handle of
Slide Plate
Move Back
4.2. Shut Height and Fine Adjustment
If shut height or fine adjustment is required, refer to
the instructions included with the press.
5. MAINTENANCE AND INSPECTION
It is a good policy to periodically inspect and clean the
seating tool assembly. Using a clean cloth, wipe dirt
and debris from the fixture board assembly. Be sure
all hardware is secure.
Occasionally lubricate the slide plate and moving
parts with a good grade lubricant.
Connectors
Base
Figure 3
Detent
CAUTION
!
DO NOT over- lubricate.
2 of 3
Tyco Electronics Corporation
Rev A