408-8503 Datasheet, PDF (1/3 Pages) Tyco Electronics – Seating Tool Assemblies

Seating Tool Assemblies 1424686- [ ]
For PC/104 and PC/104- Plus Connectors
Press (Terminator)
(Ref)
Instruction Sheet
408- 8503
05 NOV 09 Rev A
Upper (Ram) Tooling
(Included with Assemblies - 1 and - 2 Only)
Slide Plate
Base
Fixture Board Assembly
1424685- 1
SEATING TOOL ASSEMBLY
USE WITH
ALSO INCLUDED WITH
(Instruction Sheet in Parenthesis)
1424686--1
Manual Press 1428138--1
Manual Seating Tool Assembly 1424931--1
Manual Press Included (408--8505)
1424686--2
Pneumatic Press 1428137--1
Pneumatic Seating Tool Assembly 1424930--1
Pneumatic Press Included (408--8504)
1424686--3
Press Other than Manual or Pneumatic
—
Figure 1
1. INTRODUCTION
Seating Tool Assemblies 1424686--[ ] are designed to
be used to assist in applying PC/104 and
PC/104--Plus connectors to printed circuit (pc)
boards. The seating tool assembly must be installed
onto a press (refer to Figure 1).
NOTE
i
Dimensions on this sheet are in millimeters [with
inches in brackets], unless otherwise specified.
Figures are not drawn to scale.
hardware. Assemblies --1 and --2 also contain the
appropriate upper (ram) tooling for the press. The
base mounts to the press. See Figure 1. The slide
plate is detented to ensure proper location of the
connector when terminating.
3. OPERATION
1. If applying connectors with organizers, loosen
the set screws securing the insert plate, and
remove the insert plate.
Reasons for reissue of this instruction sheet are
provided in Section 7, REVISION SUMMARY.
2. DESCRIPTION
2. Align and adjust the seating tool assembly as
described in Section 4, ADJUSTMENTS.
3. If applying connectors with organizers, place the
organizer on the fixture board (in place of the insert
plate). See Figure 2.
Each seating tool assembly consists of a base, slide
plate, and Fixture Board Assembly 1424685--1 (also
available separately, refer to 408--8502), and securing
4. Place the pc board on the fixture board
assembly, locating it using the guide posts of the
fixture board assembly (shown in Figure 2).
E2009 Tyco Electronics Corporation, Harrisburg, PA TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All International Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 3
LOC B