408-7803 Datasheet, PDF (2/2 Pages) Tyco Electronics – Reasons for reissue of this instruction sheet are provided in Section 6, REVISION SUMMARY

Clinching Tool 91117-1
408-7803
end of the connector and number–coded on the
other end.
2. Place the key into the cavity at the desired
position. Insert the rivet into the back of the cavity
with the flat edge against the connector.
3. Open the tool handles, and position the tool
perpendicular to the connector.
4. Place the lower jaw on the rivet, and close the
tool punch tip through the key and into the rivet.
5. Squeeze the tool handles together until the jaws
are bottomed. Remove the tool and, if required,
repeat these procedures on the other end of the
connector.
4. MAINTENANCE AND INSPECTION
4.1. Daily Maintenance
Remove all foreign particles with a clean, soft brush
or a clean, soft, lint–free cloth. Make sure the proper
retaining pins are in place and are secured with the
proper retaining rings.
Make sure all pivot points and bearing surfaces are
protected with a thin coat of any good SAE 20 motor
oil. DO NOT oil excessively.
4.2. Periodic Inspection
It is recommended that the tool be inspected upon
arrival at your facility, and at regularly scheduled
intervals, to ensure that the tool has not been
damaged during handling.
Though recommendations call for at least one
inspection a month, the inspection frequency should
be based on the amount of use, ambient working
conditions, operator training and skill, and established
company standards.
5. REPLACEMENT AND REPAIR
Customer–replaceable parts are listed in Figure 3.
Order replacement parts through your representative,
or call 1–800–526–5142, or send a facsimile of your
purchase order to 717–986–7605, or write to:
CUSTOMER SERVICE (038–035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105–3608
For customer repair service, call 1–800–526–5136.
6. REVISION SUMMARY
Revisions to this instruction sheet include:
S Updated document to corporate requirements
S Removed obsolete connector part number
142.2 [5.60]
2.16 [.085]
Dia
ITEM
1
2
2 of 2
1
20.3 [.80]
2
4.32
[.170]
1.09 [.043] Dia
Weight: 213 g [7.5 oz]
PART NUMBER
2-21006-7
126513-1
REPLACEMENT PARTS
DESCRIPTION
SETSCREW, Socket Head, No. 6-32
PUNCH, Threaded
Figure 3
Tyco Electronics Corporation
127.0 [5.00]
(Handles Open)
QUANTITY PER TOOL
1
1
Rev E