|
408-10096 Datasheet, PDF (2/2 Pages) Tyco Electronics – Using a 5mm hex wrench, install the mounting bracket on the servo terminator as shown in Figure 2. | |||
|
◁ |
Terminal Lubricator Assembly 1752477-1
408-10096
4. ADDING LUBRICANT
When the lubricator bowl is either empty or nearly
empty, unscrew the cap and refill with E807 lubricant.
This lubricant is available from:
Stoner Inc.
1070 Robert Fulton Hwy,
Quarryville, PA 17566
Phone: 800â227â5538
Fax: 717â786â9088
www.stonersolutions.com
NOTE
i
Be sure the seal is in place in the cap before
reassembling to the bowl.
Figure 3
Also, some terminals may require âselective
lubrication.â The bowl assembly can be removed from
the mounting bracket, rotated 90_, and reâinstalled.
To adjust the wick sideâtoâside, the bowl assembly
need not be fully seated in the bracket. The
thumbscrew can be loosened, the bracket shifted
slightly side to side, and the thumbscrew
reâtightened. An example of a terminal that benefits
from selective lubrication is shown in Figure 3.
Wipe off any excess lubricant and place the bowl
assembly in the sideâ or endâfeed position.
5. REPLACEMENT
It is recommended that a spare bowl and wick be kept
on hand.
The bowl part number is currently 1804265â1. The
wick part number is currently 1804374â1. These
numbers can also be found on drawings 1752477
(Terminal Lubrication Kit) and 1804265 (Lubricator
Assembly).
3.2. End-Feed Installation
For endâfeed applications, the lubricator bowl drops
into the terminator base as shown in figure 4.
6. REVISION SUMMARY
Since the previous release of this document:
S Document format has been updated to current
corporate requirements
S Text reflects the AMPOMATOR System III
Leadmaker and AMPâOâLECTRIC Servo
Terminator III Machine
Figure 4
The wick height may be adjusted vertically as desired
to remain in constant, or intermittent, contact with the
incoming terminal strip. Usually, intermittent contact is
sufficient as some lubrication residue may remain on
the crimp tooling for several cycles.
2 of 2
Tyco Electronics Corporation
Rev B
|