408-10096 Datasheet, PDF (1/2 Pages) Tyco Electronics – Using a 5mm hex wrench, install the mounting bracket on the servo terminator as shown in Figure 2.

Lubricator
Bowl
Terminal Lubricator Assembly
1752477-1
Instruction Sheet
408-10096
15 AUG 07 Rev B
Thumbscrew
Lubricator
Mounting
Bracket
Socket Head Cap Screws
Figure 1
1. INTRODUCTION
This instruction sheet describes optional Terminal
Lubricator 1752477–1, used with the
AMP–O–LECTRIC* Servo Terminator III and the
AMPOMATOR* System III Leadmaker. See Figure 1
for the terminal lubricator assembly.
vertically as desired to remain in constant or
intermittent contact with the incoming terminal strip.
Usually, intermittent contact is sufficient since some
lubrication residue may remain on the crimp tooling
for several cycles.
Terminals made of, or coated with gold, nickel, silver
and steel require lubrication to prevent the crimped
connector from being damaged due to sticking in the
crimper. This kit applies lubrication to end or side feed
incoming product.
2. DESCRIPTION
The lubricator kit contains an adjustable mounting
(lubricator) bracket for side–feed terminals, and a
clear lubricator bowl with cap and wick. The bowl
threads into the anti–rotation cap which in turn, snaps
into the mounting bracket. Refer to Figure 1.
3. INSTALLATION
Using a 5mm hex wrench, install the mounting
bracket on the servo terminator as shown in Figure 2.
3.1. Side-Feed Installation
For side–feed applications, the lubricator bowl
assembly snaps into the mounting bracket as shown
in Figure 2. The wick height may be adjusted
Figure 2
Some applicators may require additional space and
interfere with the default mounting location shown in
Figure 2. The thumbscrew on the lubricator mounting
bracket may be loosened, and the bracket extended
to accommodate these applicators. After the bracket
is adjusted, the thumbscrew is re–tightened. An
example of an applicator that requires additional
space is shown in Figure 3.
E2007 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 2
LOC B