408-10022 Datasheet, PDF (2/2 Pages) Tyco Electronics – Die Assembly

Die Assembly 1804018- 1
408- 10022
5.1. Maintenance
1. Remove dust, moisture, and other contaminants
with a clean, soft brush, or a clean, soft, lint--free
cloth. DO NOT use any objects that could damage
the dies or tool.
2. Make sure that the retaining screws are properly
secured.
3. When the dies are not in use, store them in a
clean, dry area.
5.2. Inspection
1. Remove all lubrication and accumulated film
from the dies by immersing the dies in a suitable
commercial degreaser.
2. Make certain that all retaining screws and die
components are properly secured.
3. Inspect the crimping surfaces for flattened,
chipped, worn, or cracked areas. If damage is
evident, the dies must be replaced. Refer to
Section 8, REPLACEMENT.
5.3. Measuring the Die Opening
Measure the die opening to ensure that it meets the
dimensions given in Figure 2.
9.40 +0.03
[.370+.001]
11.87 +0.03
[.466+.001]
Note: Not to Scale
Figure 2
7. REVISION SUMMARY
Revisions to this instruction sheet include:
S Updated instruction sheet to corporate
requirements
S Removed obsolete product from Figure 1
S Added installation of pins to Steps 2 and 3 of
Section 3
S Modified Section 6
6. REPLACEMENT
Customer--replaceable parts are given in Figure 1.
A complete inventory should be stocked and
controlled to prevent lost time when replacement of
parts is necessary. Order replacement parts through
your representative, or call 1--800--526--5142, or send
a facsimile of your purchase order to 717--986--7605,
or write to:
CUSTOMER SERVICE (038--035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105--3608
2 of 2
Tyco Electronics Corporation
Rev B