408-10021 Datasheet, PDF (2/5 Pages) Tyco Electronics – The CERTI--CRIMP II Tool Holder Assembly

CERTI- CRIMP II Tool Holder Assembly 1213860- 1
Quick- Release Pin
Quick- Release Pin
Housing Center
Housing
Side
408- 10021
Housing
Side
Housing Center
Switch (Handle)
Figure 2
3. INSTALLATION AND REMOVAL
3.1. Installation and Removal of the CERTI- CRIMP II
Tool Holder Assembly 1213860- 1
A. Installation
Before mounting the CERTI--CRIMP II Tool Holder
Assembly, always make sure the guide ram of the
terminator is in the lowest position. See Figure 3.
DANGER
To avoid personal injury, be sure the SDE Electric
Bench Terminator is disconnected from the power
source prior to the installation or removal of the
tool holder assembly.
1. Be sure that the terminator has been switched
off.
2. Be sure that the CERTI--CRIMP II tool holder
assembly is mounted with the switch (handle) in
the front, to facilitate die opening and closing.
3. Mount the tool holder assembly from the back
and lock with the guide (safety) pins. Refer to
Figure 3 and Figure 4.
4. Refer to Paragraph 3.2, to remove and install
the crimping dies.
B. Removal
DANGER
To avoid personal injury, be sure the SDE Electric
Bench Terminator is disconnected from the power
source prior to the installation or removal of the
tool holder assembly.
1. Be sure the terminator has been switched “off.”
2. Remove the locating pins from the tool holder
assembly.
3. Remove and/or replace the tool holder
assembly.
4. When removing the tool holder assembly, make
sure that the guide ram of the terminator is in the
lowest position.
5. If installing or removing crimping dies, refer to
Paragraph 3.2.
3.2. Installation and Removal of CERTI- CRIMP II
Crimping Heads
DANGER
To avoid personal injury, be sure the SDE Electric
Bench Terminator is disconnected from the power
source prior to the installation or removal of the
crimping heads.
As supplied, the tool holder assembly has three
quick--release pins installed (Figure 2 and Figure 4 ).
The two outer pins will be used to secure the two
outer housing tabs of the crimp head (exposed
portion of the crimp head) to the tool holder assembly.
2 of 5
Tyco Electronics Corporation
Rev C