English
Language : 

408-10021 Datasheet, PDF (1/5 Pages) Tyco Electronics – The CERTI--CRIMP II Tool Holder Assembly
CERTI- CRIMP* II Tool Holder Assembly
1213860- 1 (for Use with the SDE Electric
Bench Terminator)
Crimping Head
Instruction Sheet
408- 10021
16 MAR 10 Rev C
CERTI- CRIMP II Tool
Holder Assembly
1213860- 1 (for use
with the SDE Electric
Bench Terminator)
SDE Electric
Bench Terminator
Figure 1
1. INTRODUCTION
The CERTI--CRIMP II Tool Holder Assembly
1213860--1 is used to adapt the crimping head from a
CERTI--CRIMP II Hand Tool to an SDE Electric
Bench Terminator. Figure 1 shows a typical crimping
head, mounted to CERTI--CRIMP II Tool Holder
Assembly 1213860--1, installed onto an SDE Electric
Bench Terminator.
For information concerning the setup and operation of
the SDE Electric Bench Terminator, refer to customer
manual 409--10052.
Read this instruction sheet, and the related customer
manual, thoroughly before using the tool holder
assembly.
2. DESCRIPTION
NOTE
i
Figures and illustrations are for reference only,
and are not to scale.
The tool holder assembly facilitates the connection of
the crimping head to the SDE Electric Bench Machine
and provides the necessary straight line motion of the
movable die when the SDE Electric Bench Machine is
actuated.
This instruction sheet provides:
S Instructions for installing and removing the tool
holder assembly to the Electric Bench Machine
S Instructions for installing the crimping head
onto the tool holder assembly
S Instructions for adjusting the crimp height
S Maintenance, inspection, and repair
instructions for the tool holder assembly
The tool holder assembly features a switch (handle)
and three quick pins. See Figure 2. The switch
(handle) can be used to manually open and close the
dies of the crimping head for insertion and removal of
the product.
The two outer quick--release pins secure the outer
tabs of the crimping head to the tool holder assembly,
and the center quick--release pin secures the the
movable die of the crimping head to the internal
spring--loaded switch of the tool holder assembly.
E2010 Tyco Electronics Corporation, Berwyn, PA
TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other product names, logos, or company names might be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 5
LOC B