M24C16_10 Datasheet, PDF (16/39 Pages) STMicroelectronics – 16 Kbit, 8 Kbit, 4 Kbit, 2 Kbit and 1 Kbit serial I²C bus EEPROM

Device operation
M24C16, M24C08, M24C04, M24C02, M24C01
Figure 10. Read mode sequences
Current
Address
Read
ACK
NO ACK
Dev select
Data out
R/W
Random
Address
Read
ACK
ACK
ACK
NO ACK
Dev select * Byte address Dev select *
Data out
R/W
R/W
Sequentila
Current
Read
ACK
ACK
Dev select
Data out 1
R/W
ACK
NO ACK
Data out N
Sequential
Random
Read
ACK
ACK
ACK
ACK
Dev select * Byte address Dev select *
Data out 1
R/W
R/W
ACK
NO ACK
Data out N
3.7
3.7.1
AI01942b
1. The seven most significant bits of the device select code of a Random Read (in the 1^st and 3^rd bytes) must
be identical.
Read operations
Read operations are performed independently of the state of the Write Control (WC) signal.
The device has an internal address counter which is incremented each time a byte is read.
Random Address Read
A dummy Write is first performed to load the address into this address counter (as shown in
Figure 10) but without sending a Stop condition. Then, the bus master sends another Start
condition, and repeats the device select code, with the Read/Write bit (RW) set to 1. The
device acknowledges this, and outputs the contents of the addressed byte. The bus master
must not acknowledge the byte, and terminates the transfer with a Stop condition.
16/39
Doc ID 5067 Rev 16