MLO80100-01020 Datasheet, PDF (1/2 Pages) Tyco Electronics – Surface Mount Voltage Controlled Oscillator EGSM 1000 - 1040 MHz

Surface Mount Voltage Controlled Oscillator
EGSM 1000 - 1040 MHz
MLO80100-01020
Features
q Miniature Size
q Surface Mount Package
q Electrically Shielded
q Low Phase Noise
q Highly Linear Tuning
Description
The MLO80100-01020 is a fundamental single ended oscillator
designed for use in cost sensitive wireless and telemetry applica-
tions. The device has been optimised by careful selection of the
bipolar transistor and varactor diode for low phase noise and
highly linear tuning characteristics.
The low profile surface mount package used provides for electri-
cal shielding, ease of assembly and repeatable performance.
M/A-COM’s surface mount manufacturing techniques together
with automated assembly and electrical testing ensure a high
degree of electrical and mechanical repeatability at low cost and
in high volume. Manufacturing is carried out in an ISO 9000
qualified facility.
LSM1 Package
4.0
0.8
IDENT
VT
12.7
11.8
VCC
M/A-COM
PART NO.
RF
DATE
V2.00
1.6
1.7
5.5
4
DETAIL A.
0.8
1
3
DETAIL A.
2
8.0
SOLDER RESIST
Electrical Specifications¹, T_A = +25°C, V_CC = +5V (unless otherwise stated)
Parameter
Test Conditions
Units
Min.
Frequency Range
MHz
1000
Tuning Voltage (V_T)²
RF Output Power³
1000 - 1040 MHz
V
+0.5
dBm
-3.0
Supply Voltage (V_CC)⁴
V
+4.75
Supply Current (I_CC)
Phase Noise⁵
SSB at 100 KHz offset from carrier
mA
dBc/Hz
Average Tuning Sensitivity⁶
1000 - 1040 MHz
MHz/V
Tuning Linearity
1000 - 1040 MHz
Ratio
Harmonic Outputs⁷
dBc
Frequency Pushing
VCC 4.75V to 5.25V
MHz/V
Frequency Pulling
1.5:1 VSWR load, all phases
MHz
Frequency Drift
-20°C to +70°C
MHz/°C
Tune Input Capacitance
pF
Typ.
+5.00
13
-127
17
1.1
-15
1.8
1.0
-0.08
Max.
1040
+4.5
+3.0
+5.25
15
-123
1.5
-12
2.5
2.0
50
1. All specifications apply with a 50 ohm load impedance.
2. Tuning voltages shown are the minimum and maximum voltages
required to tune the frequency range including temperature effects
-20°C to +70°C. Devices will oscillate normally with tuning voltages
from 0V to +10V.
3. Output power window includes unit to unit variation, temperature
effects -20°C to +70°C and frequency flatness (typically 0.5 dB at
any constant temperature).
4. Devices may be operated at lower typical supply voltage with
reduced performance.
5. For typical phase noise at other offsets see phase noise curve.
6. Defined as (1040 - 1000) / (V_T1040 - V_T1000) MHz/V.
7. Non-harmonic spurious less than -70dBc.
Specifications Subject to Change Without Notice.
M/A-COM Ltd.
North America: Tel. [phone]
Fax [phone]
s Asia/Pacific: Tel. [phone]
Fax [phone]
1
s Europe: Tel. [phone]
Fax [phone]