408-4005 Datasheet, PDF (1/6 Pages) Tyco Electronics – PRO-CRIMPER* III Hand Crimping Tool

PRO- CRIMPER* III Hand Crimping
Tool Assembly 58530- 1 with
Die Assembly 58530- 2
Instruction Sheet
408- 4005
10 NOV 09 Rev C
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended- use, production operations is available.
Locator Assembly
(Supplied with
Die Assembly)
Front of Tool
(Locator Side)
Die Assembly
Stationary Jaw
Back of Tool
(Wire Side)
Pivot Pin
Moving Jaw
PRO- CRIMPER III Hand
Crimping Tool Frame
354940- 1 ( 408- 9930)
Ratchet Adjustment Wheel
The PRO- CRIMPER III Hand Crimping Tool is a “Commercial” grade tool and is designed primarily for field installation, repair, maintenance work,
or prototyping in industrial, commercial, or institutional applications. Product crimped with this tool will meet the crimp height requirement for hand
tools in the appropriate 114 series specification, but may not comply with other feature parameters of the specification. A variety of tools is offered to
satisfy your performance requirements. For additional information, contact the Tooling Assistance Center at 1- 800- 722- 1111.
TE Die Assembly Locator Assembly{
Contact
Family}
Size
(AWG)
Wire
Insul
Dia
Strip Length
(mm [in.])
58530--2
58516--1
Universal
12
MATE--N--LOK*
Connectors
10
5.08 [.200] Max
6.35 to 7.05
[.250 to .281]
{ Supplied with die assembly. Also available separately..
} Contact the TOOLING ASSISTANCE CENTER or PRODUCT INFORMATION (see below) for specific contact part numbers.
 Anvil must be reversed when changing from one wire size to the other
Figure 1
1. INTRODUCTION
PRO--CRIMPER III Hand Tool Assembly 58530--1
consists of Die Assembly 58530--2 and
PRO--CRIMPER III Hand Tool Frame 354940--1. The
die assembly consists of crimping dies and a locator
assembly.
Read these instructions thoroughly before crimping
any contacts.
NOTE
i
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures
and illustrations are for identification only and are
not drawn to scale.
Reasons for reissue of this document are provided in
Section 11, REVISION SUMMARY.
2. DESCRIPTION (Figures 1 and 2)
The tool features a tool frame with a stationary jaw
and handle, a moving jaw, a moving handle, and an
adjustable ratchet that ensures full contact crimping.
The tool frame holds a die assembly with two
crimping sections.
The die assembly features an anvil and a crimper.
E2009 Tyco Electronics Corporation, Harrisburg, PA TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All International Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 6
LOC B