408-10227 Datasheet, PDF (1/5 Pages) Tyco Electronics – PRO–CRIMPER III Hand Tool Assembly

PRO-CRIMPER III Hand Tool
Assembly 2063291-1 with
Die Assembly 2063291-2
Instruction Sheet
408-10227
16 JUL 08 Rev A
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended-use, production operations is available.
Locator Assembly
(Supplied with
Die Assembly)
Front of Tool
(Locator Side)
Stationary Jaw
Pivot Pin
Back of Tool
(Wire Side)
Die Assembly
Moving Jaw
Ratchet Adjustment Wheel
The PRO-CRIMPER III Hand Tool is a Commercial" grade tool and is
designed primarily for field installation, repair, maintenance work, or
prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand
tools in the appropriate 114 application specification, but may not comply
with other feature parameters of the specification. Tyco Electronics offers
a variety of tools to satisfy your performance requirements. For additional
information, contact the Tooling Assistance Center at 1-800-722-1111.
PRO-CRIMPER III Hand
Tool Frame 354940-1
(See Instruction Sheet
408-9930)
Stationary Handle
Moving Handle
DIE ASSEMBLY
PART NUMBER
2063291-2
CONTACTS
1456574-2, 1456841-2, 1924275-2
1456574-1, 1456841-1, 1924275-1
SIZE (AWG)
18
20-22
WIRE
INSULATION DIA (mm)
1.60-2.06
1.50-1.85
STRIP LENGTH (mm)
4.0-4.5
Refer to Application Specification 114–13183 or Application and Termination Requirements for these contacts.
Figure 1
1. INTRODUCTION
PRO–CRIMPER III Hand Tool Assembly 2063291–1
consists of Die Assembly 2063291–2 and
PRO–CRIMPER III Hand Tool Frame 354940–1. The
die assembly consists of crimping dies and a locator
assembly. Read these instructions thoroughly before
crimping any contacts.
NOTE
i
Dimensions on this sheet are in millimeters.
Figures and illustrations are for identification only
and are not drawn to scale.
2. DESCRIPTION (Figures 1 and 2)
The tool features a tool frame with a stationary jaw
and handle, a moving jaw, a moving handle, and an
adjustable ratchet that ensures full contact crimping.
The tool frame holds a die assembly with three
crimping sections.
The die assembly features a wire anvil, an insulation
anvil, a wire crimper, and an insulation crimper.
Attached to the outside of the frame is a locator
assembly, which contains a locator, a spring retainer,
and a contact support.
Die retaining pins and die retaining screws are used
to position and secure the dies in the tool frame. A
nut is used on the upper die retaining screw to hold
the locator assembly in place.
E2008 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 5
LOC B