MAMXSS0013_15 Datasheet, PDF (3/4 Pages) M/A-COM Technology Solutions, Inc. – Low Cost MMIC Mixer

MAMXSS0013
Low Cost MMIC Mixer
1400 - 2100 MHz
Recommended PCB Configuration
Layout View
Cross Section View
Rev. V2
Lead-Free SOT-25^†
The PCB dielectric between RF traces and RF ground layers
should be chosen to reduce RF discontinuities between 50 Ω
lines and package pins. M/A-COM recommends an
FR-4 dielectric thickness of 0.008” (0.2 mm) yielding a 50 Ω
line width of 0.015” (0.38). The recommended metalization is 1
ounce copper.
†
Reference Application Note M538 for lead-free solder reflow recommendations.
Meets JEDEC moisture sensitivity level 1 requirements.
3
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: [phone] / Fax: [phone]
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
Solutions has under development. Performance is based on engineering tests. Specifications are
• Europe Tel: [phone] / Fax: [phone]
• Asia/Pacific Tel: [phone] / Fax: [phone]
Visit www.macomtech.com for additional data sheets and product information.
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. _{M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make}
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.