MAALSS0048_15 Datasheet, PDF (2/8 Pages) M/A-COM Technology Solutions, Inc. – Low Noise Amplifier

MAALSS0048
Low Noise Amplifier
1400 - 2000 MHz
Electrical Specifications³: T_A = +25°C, Z₀ = 50 Ω, P_in = -30 dBm
Parameter
Test Conditions
Units
1500 MHz
Min. Typ. Max.
Gain
Noise Figure
Input VSWR
V_DD = 3 Volts
V_DD = 3 Volts
—
dB
15
18
20
dB
—
1.60
2.00
Ratio
—
2.2:1
—
Output VSWR
—
Ratio
—
1.5:1
—
Output 1 dB Compression
Input IP3
Reverse Isolation
V_DD = 3 Volts
V_DD = 3 Volts
—
dBm
—
1
—
dBm
—
-5.0
—
dB
—
35
—
Drain Current
V_DD = 3 Volts
mA
4.5
6.5
10
3. Using external 15 Ω resistor. See Functional Schematics.
Rev. V2
1900 MHz
Min. Typ. Max.
15
17.5 20
—
1.65 2.00
—
1.5:1 —
—
1.5:1 —
—
0
—
—
-6.0
—
—
35
—
4.5
6.5
10
Absolute Maximum Ratings ^4,5
Parameter
V_DD
Input Power
Current⁶
Channel Temperature⁷
Operating Temperature
Storage Temperature
Absolute Maximum
+10 VDC
+17 dBm
30 mA
+150°C
-40°C to +85°C
-65°C to +150°C
4. Exceeding any one or combination of these limits may cause
permanent damage to this device.
5. M/A-COM does not recommend sustained operation near
these survivability limits.
6. When pin #5 is used to increase current (see note 8).
7. Thermal resistance (θjc) = +150°C/W
Lead-Free SOT-26^†
Handling Procedures
Please observe the following precautions to avoid
damage:
†
Reference Application Note M538 for lead-free solder reflow
recommendations.
Meets JEDEC moisture sensitivity level 1 requirements.
Static Sensitivity
Gallium Arsenide Integrated Circuits are sensitive
to electrostatic discharge (ESD) and can be
damaged by static electricity. Proper ESD control
techniques should be used when handling these
devices.
2
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: [phone] / Fax: [phone]
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
Solutions has under development. Performance is based on engineering tests. Specifications are
• Europe Tel: [phone] / Fax: [phone]
• Asia/Pacific Tel: [phone] / Fax: [phone]
Visit www.macomtech.com for additional data sheets and product information.
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. _{M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make}
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.