DS54-0005 Datasheet, PDF (2/4 Pages) Tyco Electronics – Low Cost Four-Way GMIC SMT Power Divider 824 . 960 MHz

DS54-0005
Low Cost Four-Way GMIC SMT Power Divider
824 – 960 MHz
Electrical Specifications: T_A = +25°C, Z₀ = 50Ω
Parameter
Insertion Loss Above 6.0 dB
Isolation
VSWR Input
Output
Amplitude Balance
Phase Balance
Units
dB
dB
—
—
dB
°
Min
—
20
—
—
—
—
Typ
0.8
24
1.4:1
1.25:1
0.3
3
Rev. V2
Max
1.1
—
1.7:1
1.5:1
0.6
6
Absolute Maximum Ratings ^2,3
Parameter
Input Power⁴
Operating Temperature
Storage Temperature
Absolute Maximum
1W CW
-40°C to +85°C
-65°C to +150°C
2. Exceeding any one or combination of these limits may cause
permanent damage to this device.
3. M/A-COM does not recommend sustained operation near
these survivability limits.
4. With internal load dissipation of 0.125 W maximum.
Handling Procedures
Please observe the following precautions to avoid
damage:
Static Sensitivity
GMIC Circuits are sensitive to electrostatic
discharge (ESD) and can be damaged by static
electricity. Proper ESD control techniques should
be used when handling these devices.
Recommended PCB Configuration
RF OUT .000
2X ° .050
PLATED THRU
RF OUT
.244
RF IN
.030 TYP.
RF OUT
12X ° .016
PLATED THRU
RF OUT
.072
2
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: [phone] • Europe Tel: [phone]
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
• India Tel: [phone]
• China Tel: [phone]
Visit www.macomtech.com for additional data sheets and product information.
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. _{M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make}
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.