DS53-0005 Datasheet, PDF (2/3 Pages) Tyco Electronics – Low Cost Three-Way GMIC SMT Power Divider 1850 . 1990 MHz

DS53-0005
Low Cost Three-Way GMIC SMT Power Divider,
1850 - 1990 MHz
Rev. V4
Absolute Maximum Ratings ^2,3
Parameter
Input Power ⁴
Operating Temperature
Storage Temperature
Absolute Maximum
1W CW
-40°C to +85°C
-65°C to +150°C
2. Exceeding any one or combination of these limits may cause
permanent damage to this device.
3. M/A-COM does not recommend sustained operation near
these survivability limits.
4. With internal load dissipation of 0.125W maximum.
Recommended PIN Configuration
Handling Procedures
Please observe the following precautions to avoid
damage:
Static Sensitivity
GMIC Circuits are sensitive to electrostatic
discharge (ESD) and can be damaged by static
electricity. Proper ESD control techniques should
be used when handling these devices.
VSWR
Typical Performance Curves
Insertion Loss
(Dashed lines show amplitude balance window)
2.0
1.5
1.0
0.5
0.0
1850
1888
1925
1963
2000
Frequency (MHz)
Isolation
2 .0
1.9
1.8
1.7
1.6
1.5
1.4
1.3
1.2
1.1
1.0
18 50
18 8 8
19 2 5
19 6 3
Fre que ncy (MHz )
2000
40
35
30
25
20
15
10
5
0
18 50
RF1-RF2
RF2-RF3
18 8 8
19 2 5
19 6 3
Fre que ncy (MHz )
RF1-RF3
2000
2
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: [phone] • Europe Tel: [phone]
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
• India Tel: [phone]
• China Tel: [phone]
Visit www.macomtech.com for additional data sheets and product information.
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. _{M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make}
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.