DS52-0014 Datasheet, PDF (2/4 Pages) Tyco Electronics – Low Cost Two-Way GMIC SMT Power Divider 1700-2000MHz

DS52-0014
Low Cost Two-Way GMIC SMT Power Divider
1700 – 2000 MHz
Rev. V4
Electrical Specifications: T_A = 25°C¹
Parameter
Test Conditions
Units
Insertion Loss Above 3.0 dB
1700 - 2000 MHz
dB
Isolation
1700 - 2000 MHz
dB
VSWR Input
RF1, RF2 Outputs
1700 - 2000 MHz
1700 - 2000 MHz
Ratio
Ratio
Amplitude Balance
1700 - 2000 MHz
dB
Phase Balance
1700 - 2000 MHz
Deg.
1. All specifications apply with a 50-ohm source and load impedance.
Min
—
16
—
—
—
—
Typ
0.6
20
1.2:1
1.1:1
0.2
1.5
Max
0.8
—
1.4:1
1.3:1
0.4
3.0
Absolute Maximum Ratings ^2,3
Parameter
Input Power⁴
Operating Temperature
Storage Temperature
Absolute Maximum
1W CW
-40°C to +85°C
-65°C to +150°C
2. Exceeding any one or combination of these limits may cause
permanent damage to this device.
3. M/A-COM does not recommend sustained operation near
these survivability limits.
4. With internal load dissipation of 0.125 W maximum.
Recommended PCB Configuration
.020 Typ.
Plated Thru Hole
6
5
4
.056
Handling Procedures
Please observe the following precautions to avoid
damage:
Static Sensitivity
GMIC Circuits are sensitive to electrostatic dis-
charge (ESD) and can be damaged by static elec-
tricity. Proper ESD control techniques should be
used when handling these devices."
1
2
3
.022
Typ.
.006
.046
Typ.
2
ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: [phone] • Europe Tel: [phone]
is considering for development. Performance is based on target specifications, simulated results,
and/or prototype measurements. Commitment to develop is not guaranteed.
PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology
• India Tel: [phone]
• China Tel: [phone]
Visit www.macomtech.com for additional data sheets and product information.
Solutions has under development. Performance is based on engineering tests. Specifications are
typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. _{M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make}
Commitment to produce in volume is not guaranteed.
changes to the product(s) or information contained herein without notice.