LT10.7MS3A10 Datasheet, PDF (3/3 Pages) Shenzhen Luguang Electronic Technology Co., Ltd – Ceramic Filter Series

LT10.7MS3A10
Ceramic Filter Series
7-7 VIBRATION
subject the filter to vibration each in x,y and z axes with the amplitude
of 1.5mm for2 hours each direction , the frequency shall be varied uniformly
between the limits of 10 to 50HZ, then release the filter into room condition for
2 hours prior to the measurement. It shall fulfill specifications in table 2
7-8 SOLDERABLLITY
dip the filter terminals no closer then 2 mm into the solder bath at 235±5℃
for 2±0.5sec. more then 95% of the terminal surface of the fllter shall be
covered with fresh solder.
7-9 LEAD FATIGUE
7-9-1 pulling test
weight along with the direction of lead without an shock 0.5 kg. the filter
shall satisfy all the initiall characteristics.
7-9-2 bending test
lead shall be subject to withstand against 90℃bending in the derection
of thickness. this operation shall be done toward both direction.the
fil ter shall show noevidence of damage and shall satisfy all the initial
electric al characteristics
TABLE 2
item
3dB Band Width drift
20dB Band Width drift
Insertion loss drift
Limit valae
±40.0KHZ max
±60.0KHZ max
2.0 dB max
8 REVIEW OF SPECIFICATION
when something gets doubtful with this specification , we shall jointly work
to get an agreement.
http://www.luguang.cn
mail:[e-mail]