LT10.7MS3A10 Datasheet, PDF (2/3 Pages) Shenzhen Luguang Electronic Technology Co., Ltd – Ceramic Filter Series

6. DIMENSIONS(mm)
LT10.7MS3A10
Ceramic Filter Series
7. ENVIRONMENTAL CHARACTERISTICS
7-1 IGH TEMPERATURE EXPOSURE
subject the fitter to +80℃ for 24 hours. then release the filter into room
condition for 4 hours prior to measurement , it shall fulfill the
the specifications in table 2.
7-2 MOISURE
keep the filter at 40℃ and 95%RH for 24 hours, then release the filter into
the room conditions for 2 to hours prior to the measurement. it shall
fulfill the specifications in table 2.
7-3 Low Temperature
subject the filter to -20℃ for 24 hours. then release the filter into the room
conditions for 4 hours prior to the measurement. it shall fulfill the specific
ations in table 2.
7-4 TEMPERATURE CYCLING
subject the filter to alow temperature of -20℃ for 30 minutes. followsing
by a high temperature of +80℃ for 30 minutes. then release the filter into the
room conditions for 1 to 2 hours prior to the mesurement. it shall meet the
specifications in table 2.
7-5 RESISTANCE TO SOLDER HEAT
dip the filter terminals no closer than 1.5mm into the solder bath at
260℃ ±10℃for 5±0.5 sec. then release the filter in to he room conditions
for24 hours. the filter shall meet the specifications in table 2.
7-6 MECHANICAL SHOCK
drop the fil ter randomly onto the concrete floor from the height of 1 meter 3
times. it shall fulfill the specifications in table 2.
http://www.luguang.cn
mail:[e-mail]