MSD50NBT Datasheet, PDF (29/38 Pages) Laird Tech Smart Technology – Added section numbering

MSD50NBT
Datasheet
Figure 7: Mounting information for MSD50NBT (version 1.1)
REFERENCE SCHEMATIC OF MSD50NBT
RF LAYOUT DESIGN GUIDELINES/PRECAUTIONS
The following is a list of RF layout design guidelines and recommendation when installing a Laird radio into your
device.
 Do not run antenna cables directly above or directly below the radio.
 Do not place any parts or run any high speed digital lines below the radio.
 If there are other radios or transmitters located on the device (such as a Bluetooth radio), place the devices
as far apart from each other as possible. Also, make sure there are at least 25dB isolation between
Bluetooth antenna and Wi-Fi antenna.
 Laird recommends the use of a double shielded cable for the connection between the radio and the
antenna elements.
 Be sure to put the capacitor on the power pin as close as possible to reduce the radiation issue.
 Use proper electro-static-discharge (ESD) procedures when installing the Laird radio module.
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/wireless
29
© Copyright 2016 Laird. All Rights Reserved
Americas: [phone]
Europe: [phone]
Hong Kong: [phone]