Q6016LH651 Datasheet, PDF (5/9 Pages) Littelfuse – 15 Amp Standard & 16 Amp Alternistor (High Commutation) Triacs

Teccor^® brand Thyristors
15 Amp Standard & 16 Amp Alternistor (High Commutation) Triacs
Figure 9: O n-State Current vs. On-State Voltage (Typical)
70
T_J = 25ºC
60
50
40
30
20
10
0
0.6
0.8
1.0
1.2
1.4
1.6
1.8
2.0
Positive or Negative Instantaneous On-State Voltage (v_T) - Volts
Figure 10: S urge Peak On-State Current vs. Number of Cycles
1000
100
Supply Frequency: 60Hz Sinusoidal
Load: Resistive
RMS On-State [I_T(RMS)]: Max Rated Value at
Specific Case Temperature
Notes:
1. G ate control may be lost during and immediately
following surge current interval.
2. O verload may not be repeated until junction
temperature has returned to steady-state
rated value.
10
1
10
100
1000
Surge Current Duration - Full Cycles
Soldering Parameters
Reflow Condition
- Temperature Min (T_s(min))
Pre Heat - Temperature Max (T_s(max))
- Time (min to max) (t_s)
Average ramp up rate (Liquidus Temp)
(T_L) to peak
T_S(max) to T_L - Ramp-up Rate
Reflow
- Temperature (T_L) (Liquidus)
- Temperature (t_L)
Peak Temperature (T_P)
Time within 5°C of actual peak
Temperature (t_p)
Ramp-down Rate
Time 25°C to peak Temperature (T_P)
Do not exceed
Pb – Free assembly
150°C
200°C
60 – 180 secs
5°C/second max
5°C/second max
217°C
60 – 150 seconds
260^+0/5°C
20 – 40 seconds
5°C/second max
8 minutes Max.
280°C
Qxx15xx & Qxx16xHx Series
111
Revised: November 1, 2010 05:04 PM
T_P
T_L
T_S(max)
T_S(min)
Ramp-up
Preheat
t_S
25
time to peak temperature
t_P
t_L
Ramp-down
Time
©2010 Littelfuse, Inc
Specifications are subject to change without notice.
Please refer to http://www.littelfuse.com for current information.