SP3001_10 Datasheet, PDF (4/6 Pages) Littelfuse – Low Capacitance ESD Protection Array

SPA™ Silicon Protection Array Products
Low Capacitance ESD Protection Array
Application Example
+5V
D2+
D2-
D1+
D1-
HDMI
or DVI
Interface
IC
D0+
D0-
Clk+
Clk-
654
SP300x-04
123
654
SP300x-04
123
D2+
Gnd
D2-
D1+
Gnd
D1-
HDMI
or DVI
Connector
D0+
Gnd
D0-
Clk+
Gnd
Clk-
Gnd
HDMI or DVI application example for the Littelfuse
SP300x-04 protection devices. A single 4 channel
SP300x-04 device can be used to protect four of the data
lines in a HDMI/DVI interface. Two (2) SP300x-04 devices
provide protection for the main data lines. Low voltage
ASIC HDMI/DVI drivers can also be protected with the
SP300x-04, the +V pins on the SP300x-04 can be
CC
substituted with a suitable bypass capacitor or in some
backdrive applications the +V_CC of the SP300x-04 can be
nPBUFE
PS
/$
Soldering Parameters
Reflow Condition
Pb – Free assembly
- Temperature Min (T_s(min))
Pre Heat - Temperature Max (T_s(max))
- Time (min to max) (t_s)
Average ramp up rate (Liquidus) Temp
(T ) to peak
L
T toT - Ramp-up Rate
S(max)
L
Reflow
- Temperature (T_L) (Liquidus)
- Temperature (t_L)
Peak Temperature (T_P)
Time within 5°C of actual peak
Temperature (t_P)
Ramp-down Rate
Time 25°C to peakTemperature (T )
P
Do not exceed
150°C
200°C
60 – 180 secs
3°C/second max
3°C/second max
¡$

60 – 150 seconds
250^+0/-5 °C
20 – 40 seconds
6°C/second max
8 minutes Max.
260°C
SP3001 Lead-Free/Green Series
42
Revised: February 9, 2010
©2010 Littelfuse, Inc.
Specifications are subject to change without notice.
Please refer to http://www.littelfuse.com for current information.