SP3010_11 Datasheet, PDF (2/4 Pages) Littelfuse – SP3010 Series 0.45pF Rail Clamp Array

TVS Diode Arrays (SPA^™Family of Products)
Low Capacitance ESD Protection - SP3010 Series
Absolute Maximum Ratings
Symbol
Parameter
Value
Units
I
Peak Current (t =8/20μs)
3.0
A
PP
p
T
Operating Temperature
-55 to 125
°C
OP
T_STOR
Storage Temperature
-60 to 150
°C
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of
the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
Electrical Characteristics (T_OP=25ºC)
Parameter
Symbol
Test Conditions
Reverse Standoff Voltage
Reverse Leakage Current
Clamp Voltage¹
Dynamic Resistance
ESD Withstand Voltage¹
V_RWM
I_LEAK
V
C
R
DYN
V_ESD
I_R ≤ 1μA
V_R=5V, Any I/O to GND
I_PP=1A, t_p=8/20μs, Fwd
I_PP=2A, t_p=8/20μs, Fwd
(V - V ) / (I - I )
C2 C1
PP2 PP1
IEC61000-4-2 (Contact)
IEC61000-4-2 (Air)
Diode Capacitance¹
C
I/O-GND
Reverse Bias=0V
Note: ¹ Parameter is guaranteed by design and/or device characterization.
Min
Typ
Max
6.0
0.1
0.5
10.8
12.3
1.5
±8
±15
0.45
Capacitance vs. Bias Voltage
Insertion Loss (S21) I/O to GND
0.6
0.5
0.4
0.3
0.2
0.1
0.0
0.0 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 5.0
I/O Bias Voltage (V)
0
-5
-10
-15
-20
-25
-30
10
100
1000
Frequency (MHz)
Units
V
μA
V
V
Ω
kV
kV
pF
10000
Clamping Voltage vs. I
PP
16.0
14.0
12.0
10.0
8.0
6.0
4.0
2.0
0.0
1.0
1.5
2.0
2.5
Peak Pulse Current-I_PP (A)
SP3010 Series
Pulse Waveform
110%
100%
90%
80%
70%
60%
50%
40%
30%
20%
10%
0%
3.0
0.0
5.0
10.0
15.0
20.0
25.0
30.0
Time (μs)
106
Revision: April 14, 2011
©2011 Littelfuse, Inc.
Specifications are subject to change without notice.
Please refer to www.littelfuse.com/SPA for current information.