LTC4006 Datasheet, PDF (9/16 Pages) Linear Technology – 4A, High Efficiency, Standalone Li-Ion Battery Charger

U
OPERATIO
1.2
1.19V
1.0
0.8
0.6
0.4
0.309V
0.2
0
0
20
40
60
80 100
I_CHARGE (% OF MAXIMUM CURRENT)
4006 F02
Figure 2. I_MON vs I_CHARGE
LTC4006
R9
32.4k _NTC
6
R_TH
10k
NTC
C7
S1
0.47µF
LTC4006
CLK
~4.5V
60k
45k
off for about 300ns at 40µs intervals. This is done to
prevent audible noise when using ceramic capacitors at
the input and output.
Charger Startup
When the charger is enabled, it will not begin switching
until the I_TH voltage exceeds a threshold that assures initial
current will be positive. This threshold is 5% to 15% of the
maximum programmed current. After the charger begins
switching, the various loops will control the current at a
level that is higher or lower than the initial current. The
duration of this transient condition depends upon the loop
compensation but is typically less than 100µs.
Thermistor Detection
The thermistor detection circuit is shown in Figure 3. It
requires an external resistor and capacitor in order to
function properly.
The thermistor detector performs a sample-and-hold func-
tion. An internal clock, whose frequency is determined by
the timing resistor connected to R_T, keeps switch S1
closed to sample the thermistor:
t_SAMPLE = 127.5 • 20 • R_RT • 17.5pF = 13.8ms,
for R_RT = 309k
The external RC network is driven to approximately 4.5V
and settles to a final value across the thermistor of:
V_RTH(FINAL)
=
4.5V
R_TH
• R_TH
+ R9
DQ
C
15k
T_BAD
4006 F03
Figure 3
This voltage is stored by C7. Then the switch is opened for
a short period of time to read the voltage across the
thermistor.
t_HOLD = 10 • R_RT • 17.5pF = 54µs,
for R_RT = 309k
When the t_HOLD interval ends the result of the thermistor
testing is stored in the D flip-flop (DFF). If the voltage at
NTC is within the limits provided by the resistor divider
feeding the comparators, then the NOR gate output will be
low and the DFF will set T_BAD to zero and charging will
continue. If the voltage at NTC is outside of the resistor
divider limits, then the DFF will set T_BAD to one, the charger
will be shut down, and the timer will be suspended until
T_BAD returns to zero (see Figure 4).
CLK
(NOT TO
SCALE)
t_SAMPLE
t_HOLD
VOLTAGE ACROSS THERMISTOR
V_NTC
COMPARATOR HIGH LIMIT
COMPARATOR LOW LIMIT
Figure 4
4006 F04
sn4006 4006is
9