LT1010_15 Datasheet, PDF (9/20 Pages) Linear Technology – Fast 150mA Power Buffer

LT1010
APPLICATIONS INFORMATION
The offset voltage specified for V_S = ±15V, V_IN = 0V and
T_A = 25°C will suffice for a worst-case condition.
V⁺
I_S
A1
V_IN
LT1010
I_S
V_OUT
A2
LT1010
∆I_OUT
I_S – ∆I_OUT
I_S + ∆I_OUT
1010 AI03
V^–
Output load current will be divided based on the output
resistance of the individual buffers. Therefore, the avail-
able output current will not quite be doubled unless output
resistances are matched. As for offset voltage, the 25°C
limits should be used for worst-case calculations.
Parallel operation is not thermally unstable. Should one
unit get hotter than its mates, its share of the output and
its standby dissipation will decrease.
As a practical matter, parallel connection needs only some
increased attention to heat sinking. In some applications,
a few ohms equalization resistance in each output may be
wise. Only the most demanding applications should require
matching, and then just of output resistance at 25°C.
Isolating Capacitive Loads
The inverting amplifier below shows the recommended
method of isolating capacitive loads. Noninverting ampli-
fiers are handled similarly.
R_S
V_IN
–
A1
LT1007
+
R_F
20k
C_F
100pF
A2
LT1010
V_OUT
C_L
1010 AI04
At lower frequencies, the buffer is within the feedback loop
so that its offset voltage and gain errors are negligible. At
higher frequencies, feedback is through C_F , so that phase
shift from the load capacitance acting against the buffer
output resistance does not cause loop instability.
Stability depends upon the R_FC_F time constant or the
closed-loop bandwidth. With an 80kHz bandwidth, ring-
ing is negligible for C_L = 0.068µF and damps rapidly for
C_L = 0.33µF. The pulse response is shown in the graph.
Pulse Response
C_L = 0.068µF
5
0
–5
C_L = 0.33µF
5
0
–5
0
50
100
150
200
TIME (µs)
1010 AI05
Small-signal bandwidth is reduced by C_F , but considerable
isolation can be obtained without reducing it below the
power bandwidth. Often, a bandwidth reduction is desirable
to filter high frequency noise or unwanted signals.
R_F
2k
R_S
2k
V_IN
–
A1
LT118A
+
C_F
1nF
A2
LT1010
V_OUT
C_L
1010 AI06
The follower configuration is unique in that capacitive
load isolation is obtained without a reduction in small-
signal bandwidth, although the output impedance of the
buffer comes into play at high frequencies. The precision
unity-gain buffer above has a 10MHz bandwidth without
capacitive loading, yet it is stable for all load capacitance
to over 0.3µF, again determined by R_FC_F .
1010fe
9