RH1498M_15 Datasheet, PDF (5/8 Pages) Linear Technology – 10MHz, 6V/s, Dual Rail-to-Rail Input and Output Precision C-Load Op Amp

RH1498M
TABLE 2A: ELECTRICAL CHARACTERISTICS
(Postirradiation) V_S = 5V; V_CM = half supply, T_A = 25°C, unless otherwise noted.
SYMBOL PARAMETER
PSRR Match
(Channel-to-Channel)
V_OUT Output Voltage
Swing Low
Output Voltage
Swing High
I_SC
Short-Circuit Current
I_S
Supply Current
SR
Slew Rate
CONDITIONS
V_S = 4.5V to 12V,
V_CM = V_O = 0.5V
No Load
I_SINK = 1mA
I_SINK = 2.5mA
No Load
I_SOURCE = 1mA
I_SOURCE = 2.5mA
V_S = ±2.5V, A_V = –1,
R_L = 10k, V_O = ±2V,
Measure at V_O = ±1V
10Krad(Si)
NOTES MIN MAX
3 82
20Krad(Si)
MIN MAX
82
50Krad(Si)
MIN MAX
82
100Krad(Si) 200Krad(Si)
MIN MAX MIN MAX
82
82
UNITS
dB
60
60
60
60
60
mV
4
100
100
100
100
100 mV
200
200
200
200
200 mV
20
20
20
20
20
mV
4
150
150
150
150
150 mV
250
250
250
250
250 mV
±8
±8
±8
±8
±8
mA
2.2
2.2
2.2
2.2
2.2
mA
2
2
2
2
2
V/µs
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: A heat sink may be required to keep the junction temperature
below this absolute maximum rating when the output is shorted
indefinitely.
Note 3: Matching parameters are the difference between amplifiers
A and B.
Note 4: Output voltage swings are measured between the output and
power supply rails.
TABLE 2: ELECTRICAL TEST REQUIREMENTS
MIL-STD-883 TEST REQUIREMENTS
Final Electrical Test Requirements (Method 5004)
Group A Test Requirements (Method 5005)
Group B and D for Class S, and
End Point Electrical Parameters (Method 5005)
*PDA applies to subgroup 1. See PDA Test Notes.
SUBGROUP
1*,2,3,4,5,6
1,2,3,4,5,6
1,2,3
PDA Test Notes
The PDA is specified as 5% based on failures from group A, subgroup 1,
tests after cooldown as the final electrical test in accordance with method
5004 of MIL-STD-883. The verified failures of group A, subgroup 1, after
burn-in divided by the total number of devices submitted for burn-in in
that lot shall be used to determine the percent for the lot.
Linear Technology Corporation reserves the right to test to tighter limits
than those given.
TOTAL DOSE BIAS CIRCUIT
40pF
5k
15V
–
5k
8V
+
–15V
RH1498 TC
For more information www.linear.com/RH1498M
rh1498mff
5