APXK004A0X-SRZ_10 Datasheet, PDF (4/25 Pages) Lineage Power Corporation – 16V Pico TLynxTM 4A: Non-Isolated DC-DC Power Modules

Data Sheet
September 13, 2010
16V Pico TLynx^TM 4A: Non-isolated DC-DC Power Modules
8 – 16Vdc input; 0.6Vdc to 8.0Vdc output; 4A output current
General Specifications
Parameter
Calculated MTBF (I_O=0.8I_{O, max}, T_A=40°C) Telcordia Issue 2 Method
1 Case 3
Weight
Min
Typ
Max
14,353,850
⎯
1.92 (0.0677)
⎯
Unit
Hours
g (oz.)
Feature Specifications
Unless otherwise indicated, specifications apply over all operating input voltage, resistive load, and temperature
conditions. See Feature Descriptions for additional information.
Parameter
On/Off Signal Interface
(V_IN=V_{IN, min} to V_{IN, max} ; open collector or equivalent,
Signal referenced to GND)
Device is with suffix “4” – Positive Logic (See Ordering
Information)
Logic High (Module ON)
Input High Current
Input High Voltage
Logic Low (Module OFF)
Input Low Current
Input Low Voltage
Device Code with no suffix – Negative Logic (See Ordering
Information)
(On/OFF pin is open collector/drain logic input with
external pull-up resistor; signal referenced to GND)
Logic High (Module OFF)
Input High Current
Input High Voltage
Logic Low (Module ON)
Input low Current
Input Low Voltage
Turn-On Delay and Rise Times
(V_IN=V_{IN, nom}, I_O=I_{O, max ,} V_O to within ±1% of steady state)
Case 1: On/Off input is enabled and then input power is
applied (delay from instant at which V_IN = V_{IN, min} until Vo =
10% of Vo, set)
Case 2: Input power is applied for at least one second and
then the On/Off input is enabled (delay from instant at
which Von/Off is enabled until Vo = 10% of Vo, set)
Output voltage Rise time (time for Vo to rise from
10% of Vo, set to 90% of Vo, set)
Output voltage overshoot (T_A = 25^oC
V_IN= V_{IN, min} to V_{IN, max},I_O = I_{O, min} to I_{O, max})
With or without maximum external capacitance
Over Temperature Protection
(See Thermal Considerations section)
Device Symbol Min Typ Max
Unit
All
IIH
⎯
10
µA
All
VIH
3.5
⎯
V_IN,max
V
All
IIL
⎯
⎯
1
mA
All
VIL
-0.3
⎯
0.8
V
All
IIH
―
―
1
mA
All
VIH
3.5
―
V_{IN, max}
Vdc
All
IIL
―
―
10
μA
All
VIL
-0.2
―
0.3
Vdc
All
Tdelay
―
2
―
msec
All
Tdelay
―
2
―
msec
All
Trise
―
4
―
msec
3
% V_{O, set}
All
T_ref
140
°C
LINEAGE POWER
4