EQW006A0B Datasheet, PDF (2/19 Pages) Lineage Power Corporation – 36 - 75Vdc Input; 12Vdc Output; 6A Output Current

Data Sheet
March 26, 2008
EQW006 Series, Eight-Brick Power Modules: DC-DC Converter
36 – 75Vdc Input; 12Vdc Output; 6A Output Current
Absolute Maximum Ratings
Stresses in excess of the absolute maximum ratings can cause permanent damage to the device. These are
absolute stress ratings only, functional operation of the device is not implied at these or any other conditions in
excess of those given in the operations sections of the data sheet. Exposure to absolute maximum ratings for
extended periods can adversely affect the device reliability.
Parameter
Input Voltage
Continuous
Transient (100 ms)
Operating Ambient Temperature
(see Thermal Considerations section)
Storage Temperature
I/O Isolation voltage (100% factory Hi-Pot tested)
Device
Symbol
Min
All
V_IN
-0.3
All
V_IN,trans
-0.3
All
T_A
-40
All
T_stg
-55
All
⎯
⎯
Max
80
100
85
125
1500
Unit
Vdc
Vdc
°C
°C
Vdc
Electrical Specifications
Unless otherwise indicated, specifications apply over all operating input voltage, resistive load, and temperature
conditions.
Parameter
Operating Input Voltage
Maximum Input Current
(V_IN= V_{IN, min} to V_{IN, max}, I_O=I_{O, max})
Input No Load Current
(V_IN = V_{IN, nom}, I_O = 0, module enabled)
Input Stand-by Current
(V_IN = V_{IN, nom}, module disabled)
Inrush Transient
Input Reflected Ripple Current, peak-to-peak
(5Hz to 20MHz, 1μH source impedance; V_{IN, min} to
V_{IN, max,} I_O= I_Omax ; See Test configuration section)
Input Ripple Rejection (120Hz)
EMC,EN5022
Device
All
All
All
All
All
All
All
Symbol
V_IN
I_IN,max
Min
36
I_{IN,No load}
I_IN,stand-by
Typ
48
75
3
Max
75
2.5
Unit
Vdc
Adc
mA
mA
I²t
1
A²s
13
mAp-p
50
dB
See EMC Considerations section
CAUTION: This power module is not internally fused. An input line fuse must always be used.
This power module can be used in a wide variety of applications, ranging from simple standalone operation to an
integrated part of sophisticated power architectures. To preserve maximum flexibility, internal fusing is not included,
however, to achieve maximum safety and system protection, always use an input line fuse. The safety agencies
require a time-delay fuse with a maximum rating of 6 A (see Safety Considerations section). Based on the
information provided in this data sheet on inrush energy and maximum dc input current, the same type of fuse with a
lower rating can be used. Refer to the fuse manufacturer’s data sheet for further information.
LINEAGE POWER
2