HAZ4000-SRU Datasheet, PDF (3/3 Pages) LEM – Current Transducers

Dimensions HAZ 4000..20000-SRU (in mm. 1 mm = 0.0394 inch)
FUJICON F2023A
6
1
6 5 43 2 1
T.P. GND OUTPUT 0V -Vc +Vc
HAZ 10000-SRU
250 +/-1.5
235
1¹6⁶¹2¹⁶²+^±/±-¹1²
200
Connection Circuit
HAZxxx-SRU
1
+Vc
2
-Vc
3
0V
4-D6
RL=10K ohm
4
OUTPUT
5
GND
T.P.
6
(Internal test point used
during factory calibrations)
Operation Principle
Terminal
M5
1...+Vc
2...-Vc
3...0V
4...OUTPUT
5...GND
Ip
6...T.P.
General tolerance +/-0.5
+Vc
Output
0V
-Vc
Mechanical characteristics
Safety
• General tolerance
• Aperture for primary conductor
• Transducer fastening
• Recommended fastening torque
• Connection of secondary
± 0.5 mm
162 mm x 42 mm
(± 2 mm)
4 x M5
(not supplied)
< 5 Nm
Fujicon F2023A
(6 terminals)
This transducer must be used in electric/electronic equipment
with respect to applicable standards and safety requirements
in accordance with the following manufacturer's operating
instructions.
Caution, risk of electrical shock
Remarks
• Temperature of the primary conductor should not exceed
120°C.
When operating the transducer, certain parts of the module can
carry hazardous voltage (eg. primary busbar, power supply).
Ignoring this warning can lead to injury and/or cause serious
damage.
This transducer is a built-in device, whose conducting parts
must be inaccessible after installation.
A protective housing or additional shield could be used.
Main supply must be able to be disconnected.
060428/2
LEM
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without previous notice.
Page 3/3
www.lem.com