HAT200-S Datasheet, PDF (3/3 Pages) LEM – Current Transducer

Dimensions HAT 200..1500-S (in mm. 1 mm = 0.0394 inch)
Top view
HAT-S SERIES
HAT 500-S to 1500-S
12
12
== = =
(unit = mm)
Positive current flow
70
30.5 x 40.5
1
4
6
Front view
HAT 200-S
Mechanical characteristics
Molex 5045-04A
78
1
90
Pins arrangement
1
2
3
4
(+)
(-) Output 0V
30.5 x 40.5
Safety
All holes O 4.5mm
Fixation by base-plate or on bus bar
with M4 screws
• General tolerance
• Transducer fastening
• Connection of secondary
± 1 mm
By base-plate or on
432 1
bus bar with M4 Molex 5045-04A
screws.
All slots ∅ 4.5 mm
Molex 5045-04A
Pins arrangement:
1
2
3
4
This transducer must⁽⁺b⁾ e u^(-)se^Od^utpi^un^t e^0Vlectric/electronic equipment
with respect to applicable stand₉a_9/r₀d₅ s and safety requirements
in accordance with the following manufacturer's operating
instructions.
Remarks
• I_S is positive when I_P flows in the direction of the arrow.
• Temperature of the primary conductor should not exceed
100°C.
Caution, risk of electrical shock
When operating the transducer, certain parts of the module can
carry hazardous voltage (eg. primary busbar, power supply).
Ignoring this warning can lead to injury and/or cause serious
damage.
This transducer is a built-in device, whose conducting parts
must be inaccessible after installation.
A protective housing or additional shield could be used.
Main supply must be able to be disconnected.
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without previous notice.
LEM Industrial
051011/9
Page 3/3
www.lem.com