|
HAS-50-S Datasheet, PDF (3/3 Pages) LEM – Current Transducer HAS 50 .. 600-S | |||
|
◁ |
Dimensions HAS 50 .. 600-S (in mm)
第ä¸è§è§
第ä¸è§è§
第ä¸è§è§
第ä¸è§è§
Mechanical characteristics
ââ General tolerance
ââ Transducer fastening
Recommended fastening torque
ââ Connection of secondary
±0.5 mm
1 hole â 4.5 mm
1 M4 steel screw
0.75 N·m (±10 %)
Molex 5045-04A
Connection
IP
UC
RM
UC
dCl
dCp
Remarks
ââ Vout is positive when IP flows in the direction of the arrow.
ââ Temperature of the primary conductor should not exceed
100 °C.
ââ Installation of the transducer must be done unless
otherwise specified on the datasheet, according to LEM
Transducer Generic Mounting Rules. Please refer to
LEM document N°ANE120504 available on our Web site:
Products/Product Documentation.
ââ Dynamic performances (di/dt and response time) are
best with a single bar completely filling the primary hole.
ââ This is a standard model. For different versions (supply
voltages, turns ratios, unidirectional measurements...),
please contact us.
30March2015/version 13
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice
Page 3/3
www.lem.com
|