HAC100 Datasheet, PDF (3/3 Pages) LEM – Current Transducers

Dimensions HAC 100..800-S (in mm. 1 mm = 0.0394 inch)
Top View
Molex 5045-04AG
4321
20
d 4.5
Left View
42
Front View
24
4.5
Mechanical char_Ta_Oc_Lte_Er_Ri_As_Nti_Ccs_{E : +/-0.5 mm}
• General tolerance^{UNLESS OTHER}±^W0^I.^S5^Em^Sm^PECIFIED
21
58
Terminal Identification
1.....+Vcc
2.....-Vcc
3.....Output
4.....0V
Safety
UNIT : mm
SCALE : 1/1
This transducer must be used in electric/electronic equipment
with respect to applicable standards and safety requirements
in accordance with the following manufacturer's operating
instructions.
0 6 111 4 / 7
Caution, risk of electrical shock
When operating the transducer, certain parts of the module can
carry hazardous voltage (eg. primary busbar, power supply).
Ignoring this warning can lead to injury and/or cause serious
damage.
This transducer is a built-in device, whose conducting parts
must be inaccessible after installation.
A protective housing or additional shield could be used.
Main supply must be able to be disconnected.
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice.
Page 3/3
www.lem.com