LT100-S-SP30 Datasheet, PDF (2/2 Pages) LEM – Current Transducer

Dimensions LT 100-S/SP30 (in mm. 1 mm = 0.0394 inch)
Front view
Left view
Secondary terminals
Terminal + : supply voltage + 12 .. 18 V
Terminal M : measure
Terminal - : supply voltage - 12 .. 18 V
Connection
Top view
LT 100-S/SP30
Mechanical characteristics
Safety
 General tolerance
 Transducer fastening
Recommended fastening torque
 Connection of primary
 Connection of secondary
± 0.5 mm
4 holes  4.3 mm
4 M4 steel screws
3.2 Nm or 2.36 Lb.-Ft.
 15 mm
Faston 6.3 x 0.8 mm
This transducer must be used in electric/electronic equipment
with respect to applicable standards and safety requirements
in accordance with the manufacturer's operating instructions.
Remarks
Caution, risk of electrical shock
 I_S is positive when I_P flows in the direction of the arrow.
 Temperature of the primary conductor should not exceed
100°C.
When operating the transducer, certain parts of the module can
carry hazardous voltage (eg. primary busbar, power supply).
Ignoring this warning can lead to injury and/or cause serious
damage.
This transducer is a built-in device, whose conducting parts
must be inaccessible after installation.
A protective housing or additional shield could be used.
Main supply must be able to be disconnected.
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without previous notice.
060911/3
page 2/3
LEM
www.lem.com