HY5-P_06 Datasheet, PDF (2/2 Pages) LEM – Current Transducers

Dimensions HY 5..25-P (in mm. 1 mm = 0.0394 inch)
36.0 Max.
32.0 Max.
JA PAN
18.0
12 .0
HY 5-P
45059
HY 10 - P
96^J3^P9²
HY 5 to 15-P
12 Max.
061027/8
(0.5)
3 x 2.54
1234
HY 20 to 25-P
( d)
10±0.3
8.5±0.3
5
6
HY 20 - P
9639
3±0.5
3 x 2.54
10±0.3
( dx2)
8.5±0.3
PCB MOUNTING DIMENSIONS (in mm ±0.1, hole -0, +0.2)
HY 5 to15-P
2 holes dia. (e)
(0.3)
(a)±0.3
3.9±0.3
PIN ARRANGEMENT
1 +15V
2 --15V
3 OUTPUT
4 0V
5 PRIMARY IN
6 PRIMARY OUT
3 x 2.54
10
8.5
HY 20 to 25-P
4 holes dia 1
holes dia (e)
3 x 2.54
(g)
(g)
10
8.5
Type
HY 05-P
HY 10-P
HY 12-P
HY 15-P
HY 20-P
HY 25-P
adeg
mm mm mm mm
1.1 0.7 1.2 --
1.4 1.1 1.6 --
1.5 1.4 2.0 --
1.5 1.4 2.0 --
1.4 1.2 1.8 1.4
1.5 1.4 2.0 1.6
Safety
This transducer must be used in electric/electronic equipment
with respect to applicable standards and safety requirements
in accordance with the following manufacturer's operating
instructions.
Caution, risk of electrical shock
When operating the transducer, certain parts of the module can
carry hazardous voltage (eg. primary busbar, power supply).
Ignoring this warning can lead to injury and/or cause serious
damage.
This transducer is a built-in device, whose conducting parts
must be inaccessible after installation.
A protective housing or additional shield could be used.
Main supply must be able to be disconnected.
Page 2/2
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice.
www.lem.com