HAX500-S_06 Datasheet, PDF (2/2 Pages) LEM – Current Transducer

Dimensions HAX 500..2500-S (in mm. 1 mm = 0.0394 inch)
HAX 500 to 2500-S
Dimensions ^{(in mm)}
56
18.5
11
18.5
11
Positive Current Flow
108
64
1
1
Fixation by base-plate or on bus bar
with M5 screws
45°
4
1
MOLEX Connector
5045-04A
126
144
Pins arrangement:
1 234
(+) (-) Output 0V
Safety
This transducer must be used in electric/electronic equipment
with respect to applicable standards and safety requirements
in accordance with the following manufacturer's operating
instructions.
060905/10
Caution, risk of electrical shock
When operating the transducer, certain parts of the module can
carry hazardous voltage (eg. primary busbar, power supply).
Ignoring this warning can lead to injury and/or cause serious
damage.
This transducer is a built-in device, whose conducting parts
must be inaccessible after installation.
A protective housing or additional shield could be used.
Main supply must be able to be disconnected.
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice.
Page 2/2
www.lem.com