 English |
|
|
|
|
|
|
|
| N9935A Datasheet, PDF (4/48 Pages) Keysight Technologies – FieldFox Handheld Analyzers | |||
| |||
| ◁ |
04 | Keysight | FieldFox Handheld Analyzers 4/6.5/9/14/18/26.5/32/44/50 GHz - Data Sheet
Cable and Antenna Analyzer and Vector Network Analyzer
The performance listed in this section applies to the cable and antenna analyzer (referred to as CAT) and vector network analyzer
(VNA) capabilities available in the following models:
ââ FieldFox RF & microwave (combination) analyzers: N 9913A, N9914A, N9915A, N9916A, N9917A, N9918A
N9950A, N9951A, N9952A
ââ FieldFox microwave vector network analyzers: N9925A, N9926A, N9927A, N9928A
NOTE: Combination analyzers = Cable and antenna tester (CAT) + Vector network analyzer (VNA) + Spectrum analyzer (SA)
Frequency specifications
N991xA, N992xA
N995xA
Frequency reference, -10 to 55 °C
Accuracy
Accuracy, when locked to GPS
Accuracy, when GPS antenna
is disconnected
Aging Rate
Frequency resolution
(start, stop, center, marker)
Frequency ⤠5 GHz
Frequency ⤠10 GHz
Frequency ⤠20 GHz
Frequency ⤠40 GHz
Frequency ⤠50 GHz
Data points of resolution
IF bandwidth 2
System impedance
Models
N9913A
N9914A
N9915A, N9925A
N9916A, N9926A
N9917A, N9927A
N9918A, N9928A
N9950A
N9951A
N9952A
Frequency range
30 kHz to 4 GHz
30 kHz to 6.5 GHz
30 kHz to 9 GHz
30 kHz to 14 GHz
30 kHz to 18 GHz
30 kHz to 26.5 GHz
300 kHz to 32 GHz
300 kHz to 44 GHz
300 kHz to 50 GHz
± 0.7 ppm (spec) + aging
± 0.4 ppm (typical) + aging
± 0.010 ppm (spec)
± 0.2 ppm (nominal) 1
± 1 ppm/yr for 20 years (spec), will not exceed ± 3.5 ppm
Spec
1 Hz
1.34 Hz
2.68 Hz
5.36 Hz
8.04 Hz
101, 201, 401, 601, 801, 1001, 1601, 4001, 10,001
Arbitrary number of points settable through front panel and SCPI
10 Hz, 30 Hz, 100 Hz, 300 Hz, 1 kHz, 3 kHz, 10 kHz, 30 kHz, 100 kHz
50 Ω (nominal), 75 Ω with appropriate adapter and calibration kit
1.â The maximum drift expected in the frequency reference applicable when the ambient temperature changes ±5 °C from the temperature when the GPS signal
was last connected
2.â VNA mode only. Recommend using averaging in CAT mode
|
▷ |
German
Russian
Spanish
Italian
Polish
Chinese
Japanese
Korean
French
Portuguese