N9935A Datasheet, PDF (19/48 Pages) Keysight Technologies – FieldFox Handheld Analyzers

19 | Keysight | FieldFox Handheld Analyzers 4/6.5/9/14/18/26.5/32/44/50 GHz - Data Sheet
Mixed-Mode S-Parameters
Mixed-mode S-parameters are also known as balanced measurements.
Measurements
Scc11
Sdd11
Scd11
Sdc11
Common mode reflection
Differential mode reflection
Differential mode stimulus, common mode response
Common mode stimulus, differential mode response
FieldFox’s mixed-mode S-parameter measurements require the use of the default factory calibration or a user 2-port calibration. So
the FieldFox analyzer must be equipped with 2-port measurement functionality to measure mixed-mode S-parameters. Mixed-mode
S-parameters are an extension of the VNA capabilities.
Vector Voltmeter (VVM)
With vector voltmeter mode, you can characterize the difference between two measurements easily. The zeroing function allows you to
create a reference signal, and characterize the difference between two device measurements. The results are shown on a large display
in digital format.
Models
Frequency range
N991xA, N992xA
N9913A
30 kHz to 4 GHz
N9914A
30 kHz to 6.5 GHz
N9915A, N9925A
30 kHz to 9 GHz
N9916A, N9926A
30 kHz to 14 GHz
N9917A, N9927A
30 kHz to 18 GHz
N9918A, N9928A
30 kHz to 26.5 GHz
N995xA
N9950A
300 kHz to 32 GHz
N9951A
300 kHz to 44 GHz
N9952A
300 kHz to 50 GHz
Setup parameters
1-port cable trimming
Reflection or S11 measurement, magnitude and phase
2-port transmission
Transmission or S21 measurement, magnitude and phase
A/B and B/A
Ratio of two receivers or channels, magnitude and phase – Need an external signal generator for the A/B or B/A
measurement
Frequency (one CW frequency point), IF bandwidth - 10 Hz to 100 kHz, output power - Low or high
Ratio accuracy (A/B and B/A)
Must zero, before measuring DUT. Recommend using a high-quality power splitter or 6 dB attenuators to minimize uncertainty due to
mismatch.
N991xA, N992xA, N995xA
Frequency
100 to 300 kHz¹
> 300 kHz to 1 MHz
> 1 to 100 MHz
> 100 to 300 MHz
> 300 MHz to 1.5 GHz
> 1.5 to 2 GHz
1.  Does not apply to N995xA models, which start at 300 kHz.
Nominal
± 1.0
± 0.4
± 0.2
± 0.4
± 0.6
± 1.0