N5171B Datasheet, PDF (29/32 Pages) Keysight Technologies – EXG X-Series Signal Generators N5171B Analog & N5172B Vector

29 | Keysight | EXG X-Series Signal Generators N5171B Analog & N5172B Vector - Data Sheet
Memory
–– Memory is shared by instrument states, user data files, sweep list files, waveform sequences, and other files
–– 3 GB (30 GB with Option 009) memory available in the N5172B
–– Security Option 006 allows storage of up to 8 GB on SD card
–– Depending on how the memory is utilized, a maximum of 1000 instrument states can be saved
Security (Option 006)
–– Removable 8 GB solid state memory (SD card) from rear panel
–– User can force all files to be stored only on external memory card including instrument states, user data files, sweep list files, waveforms, waveform
sequences, and other files.
–– Memory sanitizing, memory sanitizing on, power on, and display blanking
–– Disable USB ports
–– Note: Read/write speeds to external memory card will be slower compared to internal solid-state drive (Option 009)
Self-test
Internal diagnostic routines test most modules in a preset condition; for each module, if its node voltages are within acceptable limits, the module passes
the test
Weight
N5171B: ≤ 13.6 kg (30 lb) net, ≤ 28.6 kg (63 lb) shipping
N5172B: ≤ 15.9 kg (35 lb) net, ≤ 30.8 kg (68 lb) shipping
Dimensions
88 mm H x 426 mm W x 489 mm L (length includes rear panel feet)
(3.5 in H x 16.8 in W x 19.2 in L)
Max length (L) including RF connector tip to end of rear panel feet is 508 mm (20 in)
Recommended calibration cycle
36 months
ISO compliant
This instrument is manufactured in an ISO-9001 registered facility in concurrence with Keysight Technologies’ commitment to quality.
Inputs and Outputs
Front panel connectors
RF output
Outputs the RF signal via a precision N type female connector; see output section for reverse power
protection information
I and Q inputs
BNC input accepts “in-phase” and “quadrature” input signals for I/Q modulation; nominal input imped-
ance is 50 Ω, damage levels are 1 Vrms and 5 Vpeak
USB 2.0
Used with a memory stick for transferring instrument states, licenses and other files into or out of the
instrument; also used with U2000, U848X, and U202X Series USB power sensors
Rear panel connectors
Rear panel inputs and outputs are 3.3 V CMOS, unless indicated otherwise; CMOS inputs will accept 5 V CMOS, 3 V CMOS, or TTL voltage levels
RF output (Option 1EM)
Outputs the RF signal via a precision N type female connector
I and Q inputs (Option 1EM)
Accepts “in-phase” and “quadrature” input signals for I/Q modulation SMB connector, nominal input
impedance is 50 Ω; damage levels are 1 Vrms and 5 Vpeak; Option 1EM units will come with 2 SMB to
BNC adapters
I and Q outputs
BNC outputs the analog I/Q modulation signals from the internal baseband generator; nominal output
impedance 50 Ω, DC coupled; damage levels ± 2 V
I bar and Q bar outputs (Option 1EL)
BNC outputs the complement of the I and Q signals for differential applications;