N5171B Datasheet, PDF (20/32 Pages) Keysight Technologies – EXG X-Series Signal Generators N5171B Analog & N5172B Vector

20 | Keysight | EXG X-Series Signal Generators N5171B Analog & N5172B Vector - Data Sheet
Real-time modulation FIR filter:
Nyquist, root-Nyquist, WCDMA, EDGE, Gaussian, rectangular, APCO
25 C4FM, IS-95, User FIR
(Applies real-time FIR filtering when playing waveforms with OSR=1. Helps reduce waveform size for long
simulation times. Option 660 not required).
Real-time baseband generator (Option 660)
Real-time baseband generator required
for real-time Signal Studio
applications ¹
Cellular real-time applications
Real-time navigation
Real-time video applications
LTE-FDD, LTE-TDD, HSPA+/W-CDMA, GSM/EDGE, cdma2000^®
GPS, GLONASS, Galileo
DVB-T/T2/H/S/S2/C/J.83 Annex A/C, ISDB-T/
Note: Option 660 is not required for real-time custom modulation (Option 431)
Memory: Shares memory with Options 653 and 655
Triggering: Same as Options 653 and 655
Markers: 3 markers available, all other features are same as Options 653 and 655
Digital baseband inputs/outputs (Option 003/004)
Options 003 and 004 activate the rear panel digital I/Q bus and enables connectivity to the N5102A digital signal interface module. In output mode
(003), you can deliver realistic complex-modulated signals such as LTE, GPS, WLAN, custom pulses and many others directly to your digital devices and
subsystems. In the input mode (004), the interface module ports your digital input to the signal generator's baseband system, providing a quick and easy
way of upconverting to calibrated analog I/Q, IF, or RF frequencies. In both operating modes, the interface module adapts to your device with the logic
type, data format, clock features, and signaling you require.
Data (requires N5102A)
Digital data format
User-selectable: 2's complement or binary offset, I/Q (I, I-bar, Q, Q-bar) or digital IF output (real, imaginary)
Data port
Dual 16-bit data buses support parallel, parallel I/Q interleaved, parallel QI interleaved, or serial port
configuration
N5102A connectors (breakout boards)
144-pin Tyco Z-Dok+ connects to break-out boards (included with N5102A) that interface with the following
connector types: 68-pin SCSI, 38-pin dual AMP Mictor, 100-pin dual Samtec, 20-pin dual 0.1 inch headers,
40-pin dual 0.1 inch headers
Logic types
Single-ended: LVTTL, 1.5V CMOS, 1.8V CMOS, 2.5V CMOS, 3.3.V CMOS
Differential: LVDS
Data output resampling
EXG baseband output is resampled to the arbitrary clock rate set by the user via real-time curve-fit
calculations.
1.  See www.keysight.com/find/signalstudio for more information.