C0201C103B1GA Datasheet, PDF (7/8 Pages) Kemet Corporation – CERAMIC CHIP CAPACITORS

CERAMIC CHIP CAPACITORS
Packaging Information
Punched Carrier (Paper Tape) Configuration (Ceramic Chips Only):
Bottom
Tape
Cover
T
Top
Tape
Cover
P₀
D₀
P₂
A₀
B₀
10 pitches cumulative
tolerance on tape
±0.2 (±0.008)
E
F
W
T₁
User Direction of Feed
G₂
P₁
Max. Cavity Size
See Note 1
Table 1
Center lines
of cavity
Table 1: 8 & 12mm Punched Tape
(Metric Dimensions Will Govern)
Constant Dimensions - Millimeters (Inches)
Tape
Size
D₀
E
P₀
P₂
T₁ G₁ G₂
R Min.
8mm
1.5
1.75 ±0.10 4.0 ± 0.10 2.0 ± 0.05 0.10 0.75 0.75 25 (.984)
and +0.10, -0.0
(.004) (.030) (.030) See Note 2
12mm (.059 (.069 ±0.004) (.157 ± 0.004) (.079 ± 0.002) Max. Min. Min. Table 1
+0.004, -0.0)
Table 1: 8 & 12mm Punched Tape
(Metric Dimensions Will Govern)
Variable Dimensions - Millimeters (Inches)
Tape
Size
P₁
F
W
A₀B₀
T
8mm
1/2
Pitch
8mm
2.0 ± 0.10
(.079 ±.004)
See Require-
3.5 ± 0.05
ments
Section 3.3 (d)
(.138 ± .002)
4.0 ± 0.10
(0.157 ± .004)
12mm 4.0 ± 0.10
(0.157 ± .004) ^{5.5 ± 0.05}
12mm
Double
8.0 ± 0.10
(0.315 ± .004)
(.217 ± .002)
Pitch
8.0 ± 0.3
(.315 ± 0.012)
12.0 ± 0.3
(.472 ± .012)
See Note 1
Table 1
1.1mm (.043)
Max. for Paper
Base Tape and
1.6mm (.063)
Max. for Non-
Paper Base
Compositions.
See Note 3.
Note:
1. A0, B0 and T determined by the maximum dimensions to the ends of the terminals extending from the
body and/or the body dimensions of the component. The clearance between the ends of the terminals or
body of the component to the sides and depth of the cavity (A0, B0 and T) must be within 0.05mm (.002)
minimum and 0.50mm (.020) maximum. The clearance allowed must also prevent rotation of the component
within the cavity of not more than 20 degrees (see sketches A and B).
2. Tape with components shall pass around radius "R" without damage.
3. KEMET nominal thicknesses are: 0402 = 0.6mm and all others 0.95mm minimum.
Sketch A:
Bending Radius
See Note 2
Table 1
R
(Min.)
20°
Sketch B:
Max. Component
Rotation - Front
Cross Sectional View
Sketch C:
Component Rotation - Top View
Maximum
20° ^{component rotation.}
Typical
component
center line
96
©KEMET Electronics Corporation, P.O. Box 5928, Greenville, S.C. 29606, [phone]