FA0H104ZF Datasheet, PDF (5/13 Pages) Kemet Corporation – Supercapacitors FA Series

Supercapacitors – FA Series
Specifications cont’d
Item
FA Type
Lead Strength (tensile)
Vibration Resistance
Capacitance
ESR
Current (30 minutes value)
Appearance
No terminal damage
Satisfy initial ratings
No obvious abnormality
Solderability
Over 3/4 of the terminal should be covered by the new
solder
Solder Heat Resistance
Temperature Cycle
High Temperature and High
Humidity Resistance
High Temperature Load
Capacitance
ESR
Current (30 minutes value)
Appearance
Capacitance
ESR
Current (30 minutes value)
Appearance
Capacitance
ESR
Current (30 minutes value)
Appearance
Capacitance
ESR
Current (30 minutes value)
Appearance
Satisfy initial ratings
No obvious abnormality
Satisfy initial ratings
No obvious abnormality
> 90% of initial value
≤ 120% of initial ratings
≤ 120% of initial ratings
No obvious abnormality
> 80% of initial value
< 120% of initial ratings
< 200% of initial ratings
No obvious abnormality
Test Conditions
(conforming to JIS C 5160-1)
Conforms to 4.9
Conforms to 4.13
Frequency: 10 to 55 Hz
Testing Time: 6 hours
Conforms to 4.11
Solder temp: +245 ±5ºC
Dipping time: 5 ±0.5 seconds
1.6 mm from the bottom should be dipped.
Conforms to 4.10
Solder temp: +260 ±10ºC
Dipping time: 10 ±1 seconds
1.6 mm from the bottom should be dipped.
Conforms to 4.12
Temperature
Condition:
Number of cycles:
-25ºC→ Room
temperature→ +70ºC→
Room temperature
5 cycles
Conforms to 4.14
Temperature:
Relative humidity:
Testing time:
+40 ±2ºC
90 to 95% RH
240 ±8 hours
Conforms to 4.15
Temperature:
Voltage applied:
Series protection
resistance:
Testing time:
+70 ±2ºC
Maximum operating
voltage
0Ω
1,000 +48 (+48/-0) hours
Marking
Date
code
Serial
number
A1
001 FA 5 V
0.1 F
A1
001 FA 5 V
0.1 F
FA 5 V
0.1 F
FA 5 V
0.1 F
Rated voltage
Nominal
capacitance
Negative polarity
identification mark
© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 [phone] • www.kemet.com
S6018_FA • 3/7/2014 5